This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. T...
$16.47
In Stock
Order within the next 7 hrs and your part ships today!
Order within the next 7 hrs and your part ships today!
Questions And Answers for EFLW427UIW1
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Joe
September 13, 2023
How to replace a one belt
For model number EFLW427UIW1
Hi Joe, thank you for your inquiry. Before you replace the drive belt in your washer, be sure to unplug the power cord. Unthread the screws securing the rear access panel. Set the panel aside. Carefully rotate the drive pulley to help remove the old belt if still intact. Install the new drive belt by hooking it onto the motor shaft then loop the belt on the drive pulley and rotate the pulley to align the belt. Reposition the rear access panel. Thread and tighten the screws to secure. With the repair completed plug the power cord back in and your washer should be ready for use. We hope that helps!
Was this helpful?
Thank you for voting!
Colleen
29 days ago
I can't locate the Washer Drain ?? Everything says on the front. But nothing ???
Please help...
For model number EFLW427UIW1
Hello Colleen, thank you for your inquiry. According to our research, the drain pump, part number PS11766082, for your model is located at the front bottom. You may need to remove the front panel of the washer to access the drain pump. Glad to be of help!
I googled the problem, read the recommendation found the part and read that it was an easy fix. Took the broken part off the door and noticed the broke off piece was in the latch on the machine. Ordered the two parts, paid the $30 2-day delivery. Parts arrived and the machine was up and runnning in under 5 minutes
Remove two screws on attachment plate slide door lock plate out. Disconnect wire harness. Remove two screws on back side. Then reverse the process, done!
P.S. don't pay $32 for next working day it still took 3 days to arrive. doesn't help when your leaving in two.
Ruemove the back panel with a square drive bit. Belt removal was easy: rotate the large whelk while coaxing the belt off with hand pressure from behind. Comparing the old to new belts, the circumference difference was about 2”. Loop the new belt over the small motor wheel and start looping over the big drum wheel; it will be reluctant. Place a small smooth pry bar between the belt and wheel while rotating the big wheel using the bar to keep the belt on the wheel. Then turn the big wheel by hand a few times to assure the belt rides correctly.