This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. T...
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Sheri
September 15, 2023
We are looking for a stacking kit for the Electrolux LuxCare Washer and Dryer with the dryer model number EFLW427UIW0. Is there a stacking kit for these models?
Thank you!
For model number EFLW427UIW0
Hello Sheri, thank you for the great question. The stacking kit you are looking for is part number PS11766546. Glad to be of assistance!
My washer constantly pauses throughout the load cycle. I have to press start to keep it going. It typically stops at minute 33 and 15 left to go when on the normal cycle. The fast cycle causes the machine to go into Error code 11. I replaced the door latch and the switch assembly it locks into. This has not solved the problem.
For model number EFLW427UIW0
Hi Sacha, thank you for your inquiry. According to our research, if the error code is E11, it indicates that the washer is taking too long to fill with water. Considering the remaining issues, we would recommend replacing the control board, part number PS12705780, to solve the problem. It manages the washer's functions such as filling, washing, draining and spinning. We hope that helps!
I googled the problem, read the recommendation found the part and read that it was an easy fix. Took the broken part off the door and noticed the broke off piece was in the latch on the machine. Ordered the two parts, paid the $30 2-day delivery. Parts arrived and the machine was up and runnning in under 5 minutes
Remove two screws on attachment plate slide door lock plate out. Disconnect wire harness. Remove two screws on back side. Then reverse the process, done!
P.S. don't pay $32 for next working day it still took 3 days to arrive. doesn't help when your leaving in two.
Ruemove the back panel with a square drive bit. Belt removal was easy: rotate the large whelk while coaxing the belt off with hand pressure from behind. Comparing the old to new belts, the circumference difference was about 2”. Loop the new belt over the small motor wheel and start looping over the big drum wheel; it will be reluctant. Place a small smooth pry bar between the belt and wheel while rotating the big wheel using the bar to keep the belt on the wheel. Then turn the big wheel by hand a few times to assure the belt rides correctly.
