CTH14CYSCRWH Hotpoint Refrigerator - Instructions

Took old cover off, put new cover in.

it was slowing cracking for a long time, and repairs with duct tape and crazy glue were a futile attempt to avoid the inevitable; a new part altogether! Well a few moments searching your site for the exact piece were all that was needed. With 48 hours of placing the order I had it in my apartment and just slipped it into place! it was a piece of cake!Thank you so much!

My wife and I followed the installation video & put the gasket in hot water. We struggled to get it started in the second corner on top. Gasket had cooled down so wasn't wanting to go in the slot. I finally got the bright idea to use a hair dryer to warm the gasket as we pushed it along.
That helped us finish the installation.
Not sure the new gasket is the complete answer to the leakage at the top of the door (forming ice crystals). The MAGNETS ARE WEAK compared to my 1 year old GE top freezer refrigerator!
My newer refrigerator "snaps" shut.

Just as your video described, although due to the age of the fridge, it took a bit longer to remove the defective switch. Your video made this so simple, I can't imagine why we lived with a dark fridge for so long! I was ready to buy a whole new fridge, as repairmen are often nonexistent for small repairs. I am the biggest fan of your company & it's repair video. THANK YOU SO MUCH

We thought we would have to replace our frig, but found the part online and it fit perfectly. It's slightly different than the original because it is stronger. All we did was remove the items from the tray, unsnap the broken one and slide the new one into place.

Using plyers Pulled old switch down and out. Put new one in and pushed new switch up into position. The switch plugs into the contacts, no wiring needed. Worked like a charm. You saved me 200 dollars GE repair bill. Thanks

Very easy

I started at the compressor and replaced the overload and the Ptcr first and that did not make the compressor start running again, so I replaced the capasitor and it still did not start, so I bit the bulett and replaced the Main Control Board and that is what I should have checked first, when I removed the old one I found a little burnt spot on the back that I could not see from the front. The new one did not look exactly like the old one, it had two more wire terminals than the old one, but just leave them blank and everything will work just fine!

Had to e-mail GE for electrical schematic. Checked voltages to compressor. Jumpered compressor to see if it would even come on. Found bad run capacitor. Fixed.

I took it right out of the framed box to keep the gasket in shape and snapped it back on the gasket mount on the freezer door it took 5 minutes or less perfect fit

Removed Ice shelf,
Remove rectangle cover by removing the two screws and lifting straight up.
Pulled fan off slowly.
Removed two hex screws holding motor bracket.
Remove cover.
Remove two hex screws holding remaining bracket from fridge.
Pull wire off motor noting where they were plugged in.
Pull apart brackets holding motor and remove motor noting how the motor and brackets fit together.
Reverse to install.

Removed Veg Drawers and old cover. Installed new cover and replace drawers after cleaning. No tools needed and did not have to use spacers, though I did save them.

Replaced vegetable drawer cover with new one

Super easy, remove drawers, remove broken shelf, slide new shelf into slots and return crisper drawers to their new support system. Very speedy receipt of appliance part and it took about 5 minutes to make change. Thanks much.

Simply removed old broken part and inserted new. It was just too easy