CGE29DP3TBD1 General Electric Refrigerator - Overview
Sections of the CGE29DP3TBD1
[Viewing 13 of 13]
Keep searches simple, eg. "belt" or "pump".
FILTER ASM XWFE
PartSelect #: PS16542726
Manufacturer #: WR01F04788
This water filter assembly helps reduce contaminants to improve water clarity and taste. Clean filtration protects internal components and enhances user satisfaction. Replacing the filter assembly res...
$127.31
In Stock
Order within the next 3 hrs and your part ships today!
FASTENER DOOR HANDLE
PartSelect #: PS10065354
Manufacturer #: WR01A01801
$19.39
In Stock
Order within the next 3 hrs and your part ships today!
Refrigerator Set Screw
PartSelect #: PS8767906
Manufacturer #: WR01X20424
If you're struggling with a refrigerator that's not running like it used to, the GE Set Screw could be your solution. This small but mighty piece is crucial for your fridge's efficiency and performanc...
$13.95
Special Order
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
freezer temperature was warm, but freezer evaporator frozen
unplugged the electrical connection from the wall, took out the top and bottom shelves from the freezer (freezer located in the lower part of fridge)
took out the freezer door by unscrewing 4 screws (2 on the right 2 on the left) unscrew 2 screws on the back panel, unplugged the fan cables to uncover the evaporator, disconnected the thermistor, cut the wire about 1/2 inch, unhooked and unplugged the defrost heater, unscrew 1 screw.
with 2 Splice Lock Wire Terminals connected the new thermistor with the old thermistor wires and placed it back to the evaporator.
placed the new defrost heater to the bottom of the evaporator, screwed 1 screw back and plugged it back.
took out the freezer door by unscrewing 4 screws (2 on the right 2 on the left) unscrew 2 screws on the back panel, unplugged the fan cables to uncover the evaporator, disconnected the thermistor, cut the wire about 1/2 inch, unhooked and unplugged the defrost heater, unscrew 1 screw.
with 2 Splice Lock Wire Terminals connected the new thermistor with the old thermistor wires and placed it back to the evaporator.
placed the new defrost heater to the bottom of the evaporator, screwed 1 screw back and plugged it back.
Parts Used:
-
Generoso from Ocala, FL
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!