This NSF-certified water filter helps to improve the taste, quality, and health of your water by removing a number of contaminants including mercury, lead, and trace pharmaceuticals. The filter should...
This is a door handle fastener to secure the handle to your refrigerator drawer. It is also known and a mounting bolt or screw. It is approximately 1 inch in total length, and is made of metal.
This evaporator fan motor is for refrigerators.
The evaporator fan motor circulates air through the fresh food compartment for efficient cooling.
Safely store any food that could deteriorate whi...
This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. This part has been updated by the manufacturer and may appear different t...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Tim
March 3, 2023
How to place lights on the side of fridge
For model number CFE28TSHOSS
Hello Tim, thank you for the great question. If you need to replace the LED lights in your fridge, you can use a flat-blade screwdriver to do so. Start by inserting the screwdriver and pushing it in slightly to pry out the LED cover. Then, pull it out a little bit, but be mindful of the wire harness, as it will prevent the cover from going too far. Next, press down on the locking tab to disconnect the plug. Once you have removed the old LED, you can bring in the new one and plug it in. Push it in until it locks in place, and then install it by placing it in and pushing it in. After completing these steps, you can close the doors of the fridge and plug it back in. With these simple steps, you can replace the LED cover on your fridge and keep it functioning properly. We hope this helps, good luck with this repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
I went to a GE repair center to explain my problem, the service center reccomended that I have a techinician come out o look at it. $75.00 for the visit and what ever labor and materials wuld cost.
I went on line to see if there were others having this same problem and found that there were many with the same problem.
After reading some of the ways that people found out what was wrong ...it became a matter of three components, the timer, heater or thermostat.
I tried the most common component and the less expensive one first , the thermostat switch I installed it very easily snipping two wires and attaching the news using wire nuts I used the diagram on this website to pinpoint the component and there has not been a problem since.
went to your website and viewed exploded view to find the sensor( there are two I just picked one to replace for now), pried the cover off carfully and pulled out the sensor. I snipped the wire in the middle leaving plenty to work with. I shortened the wire on the new piece, spliced the wires together and with some 3M rubberized, tape wrapped them up, replaced the sensor back into the cover and snapped in place.