9114338690 Kenmore Cooktop - Instructions

Replacement was simple. Old switch was easily removed. Once I swapped the wires from old to new we were in business. One thing I would do differently than the included directions called for. I wish I had waited until I had installed the new switch to set the shaft length. I snapped off one too many sections of the shaft after measuring the original shaft as recommended. If I had installed the replacement switch and then set the shaft length it would have been more accurate. Everything still works but one knob is now slightly lower than the other three.

We did the repair by following the inclosed instructions. we are elderly retired average ages 82. This was our first repair and it went very well. We are so pleased to have saved over $80.00 compared with hired labor 3 yre. ago for the same part. Thanks so much for your good service.

I did as the video suggested.....I cut the old wires and spliced new ones already attached to the new terminal block. It would have been nice to have some instructions with the parts as I expected one piece but had to connect the wires to the new block and the new metal cover. I was guessing a bit. Also, I needed to use the holder strip off my old part so that it displaced the new part back far enough to insert the burner connections. That meant finding a screw and nut small enough to allow the metal cover to fit on the block. But the burner works great. I've learned that any repair requires some ingenuity.

We are really excited to have this burner working again. We originally paid a repairman to come out and he said that he couldn't get parts so we would just have to live with it or replace the whole cooktop. We received the new burner within a few days of ordering. I pulled the two burner unit out of the cooktop, easily removed about 7 nuts and had access to the burners. It was a perfect replacement and fit right in. The only place I had to spend a little extra time was where the connection wires are screwed to the burner. One unscrewed but the other one broke and I had to cut it off the old unit and remove a little wire insulation before re-installing.

changed burner and replace light receptical. easy job great service from supplier.

the original path was from the right front control knob around the back of the range and left side of range,which i dismantaled to install the new wires to the right front burner. When I found them to be to short I had to also dismantal the right side so the wires could be routed there. The new wires worked fine but did take some extra time.