8351VS Magic Chef Cooktop - Overview
Sections of the 8351VS
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Top Burner Igniter
PartSelect #: PS2082000
Manufacturer #: 74004053
This top burner igniter comes with a mounting bracket.
$35.46
In Stock
Screw
PartSelect #: PS12349731
Manufacturer #: W11233072
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$28.95
In Stock
Burner Head Cap with Spark Electrode
PartSelect #: PS11741732
Manufacturer #: WP3412D024-09
This is a black burner head with the spark electrode.
NOTE: This part has been updated and there is no longer a gasket seal required.
$114.98
In Stock
Spark Module - Oven
PartSelect #: PS2094592
Manufacturer #: 8215557
This part sends enough current to the igniter to create a spark to the bottom of the burner cap.
$143.12
In Stock
Stand Mixer Screw
PartSelect #: PS11742292
Manufacturer #: WP4159193
This screw is sold individually.
$11.95
In Stock
Igniter Wire
PartSelect #: PS11742785
Manufacturer #: WP5111A360-60
This igniter wire is twenty-eight inches long.
$12.04
Special Order
Appliance Screw
PartSelect #: PS11743002
Manufacturer #: WP59002061
Sold individually.
$9.85
In Stock
GRATE BURNER
PartSelect #: PS12731250
Manufacturer #: W11400301
This square burner grate has sides measuring approximately nine inches. It is all black in color.
$140.18
Special Order
Range Screw 632 X 5/16
PartSelect #: PS11744050
Manufacturer #: WP74004005
This screw is well under an inch long, and is made of metal.
$9.85
Special Order
Range Frame Screw
PartSelect #: PS11743908
Manufacturer #: WP7101P126-60
Sold Individually.
$9.85
In Stock
Pressure Regulator
PartSelect #: PS11744587
Manufacturer #: WP7510P083-60
This valve automatically cuts off the flow of gas at a certain pressure.
No Longer Available
REGULATOR
PartSelect #: PS12074765
Manufacturer #: W11106948
This pressure regulator is three inches long. It is made of metal, but has a blue plastic plug on each end. This regulator sits below a gas range's control panel.
$196.02
In Stock
Common Symptoms of the 8351VS
[Viewing 4 of 4]Will Not Start
Fixed by
these parts
these parts
Show All
Gas igniter glows, but will not light
Fixed by
these parts
these parts
Show All
Element will not heat
Fixed by
these parts
these parts
Show All
Gas smell
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
gas burner ignitor failure
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt had built up around burner to pan connection.I used my oil filter wrench to turn slightly the burner to remove it from the pan to clean.Reassembled in reverse order.
Parts Used:
-
roy from East Providence, RI
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
142 of 162 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
top burners on stove won't ignite ,no clicking noise
remove small panel on right side of stove,then un clip moduke and put wires from old module to new one.
Exact fit nomproblems.
Exact fit nomproblems.
Parts Used:
-
scott from centreville, VA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
48 of 73 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Burner wouldn't start
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.
That's it!
That's it!
Parts Used:
-
Yury from Brooklyn, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
35 of 48 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!