81560-2 General Electric Freezer - Overview
Sections of the 81560-2
[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
White Touch up Paint
PartSelect #: PS467298
Manufacturer #: 5303321319
This 18 ml bottle of white appliance touch up paint is a little over two inches tall. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers.
$29.95
In Stock
GASKET-DOOR
PartSelect #: PS2378625
Manufacturer #: 216481211
Are you trying to keep your Frigidaire appliance running optimally? The key might just be our high-quality Frigidaire White Door Gasket. Designed specifically for select Frigidaire models, this origin...
$233.55
In Stock
Compressor Kit
PartSelect #: PS11770703
Manufacturer #: 5304507765
Keep your refrigerator or freezer running efficiently with this complete compressor kit. The compressor serves as the heart of the cooling system, pressurizing and circulating refrigerant through the ...
$910.25
In Stock
Common Symptoms of the 81560-2
[Viewing 4 of 4]Frost buildup
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Won’t start
Fixed by
these parts
these parts
Show All
Freezer section too warm
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Clicking sound then within a minute clicking again, not cooling.
UNPLUG REFRIGERATOR. Carefully remove relay from the side of the compressor. You shouldn't need a tool to do this, if it is hard you can gently pry the edge with a flat head screw driver just to loosen. Unplug white and red wires from relay, noting that the white wire goes in the hole with a #2 stamped beside it. Shake old relay, if it rattles like a baby rattler then it's most likely the problem. Replace wires into the new relay and plug back into the compressor.
Parts Used:
-
Melvin from Semmes, AL
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
81 of 97 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door gasket needed to be replaced.
I removed all of the expandable pins that held the gasket and the inner door panel, and removed the old gasket from the inner door panel. The new gasket was then placed around the edges of the inner panel. While holding the gasket and panel in the proper location, the expandable pins were inserted into the mounting holes, finishing the installation.
Parts Used:
-
Arnold from Quincy, IL
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
24 of 32 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Stopped working, cooling.
I used a small screwdriver to disconnect wires from old starter. I connected the overload and starter, two wires. I put the unit back in the keeper, plugged the unit in, turned up the thermostat and it's working beautifully.
Parts Used:
-
Jennifer from Jonestown, TX
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
15 of 19 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!