80860 General Electric Freezer - Overview
Sections of the 80860
[Viewing 1 of 1]
Exact Part matches for your search term
[Viewing 1 of 1]
STATOR *REPLACE
This part number matches the current model number 80860
PartSelect #: PS2093720
Manufacturer #: 80860
No Longer Available
Keep searches simple, eg. "belt" or "pump".
Run Capacitor
PartSelect #: PS2333670
Manufacturer #: 5304464438
This part is attached to the compressor. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.
$58.82
In Stock
Access Panel Retainer
PartSelect #: PS414912
Manufacturer #: 08017037
Sold individually.
$6.18
In Stock
COLD CONTROL KIT
PartSelect #: PS9865018
Manufacturer #: 5304496560
This part helps maintain the desired temperature.
$62.10
Special Order
Freezer Lid Gasket
PartSelect #: PS296701
Manufacturer #: WR24X10006
The gasket creates a seal around the lid to prevent warm air from entering the freezer.
$236.58
Special Order
Common Symptoms of the 80860
[Viewing 10 of 10]Will Not Start
Fixed by
these parts
these parts
Show All
Fridge too warm
Fixed by
these parts
these parts
Show All
Freezer section too warm
Fixed by
these parts
these parts
Show All
Won’t start
Fixed by
these parts
these parts
Show All
Too warm
Fixed by
these parts
these parts
Show All
Fridge and Freezer are too warm
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Fridge runs too long
Fixed by
these parts
these parts
Show All
Doesn’t stop running
Fixed by
these parts
these parts
Show All
Clicking sound
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Clicking sound then within a minute clicking again, not cooling.
UNPLUG REFRIGERATOR. Carefully remove relay from the side of the compressor. You shouldn't need a tool to do this, if it is hard you can gently pry the edge with a flat head screw driver just to loosen. Unplug white and red wires from relay, noting that the white wire goes in the hole with a #2 stamped beside it. Shake old relay, if it rattles like a baby rattler then it's most likely the problem. Replace wires into the new relay and plug back into the compressor.
Parts Used:
-
Melvin from Semmes, AL
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
81 of 97 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
buttom of refrigerator not cold
unplug it, pulled compressor start relay,which i thing it was the problem, but i replace bolt, very easy.
Parts Used:
-
Giuseppe from brick, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
23 of 29 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
just quit working
-
Denise from Lowell, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
19 of 25 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!