This refrigerator water filter replacement is for 2010 LG refrigerators that have either forward French doors or are the four-door dispensing models. This filter is designed to minimize impurities tha...
$77.99
In Stock
Order within the next 4 hrs and your part ships today!
This spring is located on the mullion, or door flap, of your fridge. This spring is sourced from the genuine OEM manufacturer for various refrigerator models. It measures about 1.5 inches in total len...
$15.35
In Stock
Order within the next 4 hrs and your part ships today!
This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your...
$13.15
In Stock
Order within the next 4 hrs and your part ships today!
This deli drawer is for refrigerators. Deli drawer holds meats, vegetables and snacks in the fresh food compartment of the refrigerator. Follow the instructions in the owner's manual when installing this part.
$147.07
In Stock
Order within the next 4 hrs and your part ships today!
This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh ...
$216.10
In Stock
Order within the next 4 hrs and your part ships today!
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Cesar
September 21, 2022
freezer compartment not freezing
For model number 79572032111
Hello Cesar, thank you for your question. Dirty condenser coils can considerably reduce freezer performance, they should be clean and dust free. Secondly, check the evaporator fan motor (part number: PS3523323) and make sure the evaporator fan is good. Next is to check the defrost sensor (part number: PS3636324), it is the part that prevents the freezer from getting too warm and controls the function of defrosting. A defective defrost heater (part number: PS3527753) can cause over-melting and prevent the freezer from freezing. Next, you need to check the condenser fan (part number: PS3523330), if it is not working the condenser will not be able to freeze in the freezer. We look forward to hearing from you if you need assistance with placing an order through our 7-days-a-week customer service. We hope this helps!
My Kenmore Model 795.72032111 refrigerator runs constantly. Both the refrigerator and freezer are not cold
For model number 79572032111
Hi Nancy, thank you for contacting us. The issue seems to be with the sealed system, like the compressor, part number PS12739218. You may need to replace it to fix the issue. We hope this sorts out your problem!
1. Shut off water to refrigerator. 2. Removed bottom sheet metal cover (6 screws). 3. Removed leaking water inlet valve assembly from refrigerator (1 screw). 4. Remove water inlet tube (loosen nut) and tube back to refrigerator (pull from water valve after remove cotter pin washer). 5. Detach two electrical wire harnesses. 6. Install new water inlet valve assembly to refrigerator (1 screw). 7. Replace both water tubes to water inlet assembly. 8. Re-attach both wiring harnesses. 9. Turn water to refrigerator on. 10. Check for leaks. 11. Re-attach bottom sheet cover (6 screws).
Video makes it look easy. Kenmore refrigerator does not have "groove" along the right hand side of switch that allows for pushing down on release. Used a thin screwdriver to get under to push while holding switch edge with pliers. Kept slipping. Tape sides to avoid scratching inside of refrigerator.
The Refrigerator now runs very quite. After watching several videos I started on mine and found that it was a bit different than any in the videos. However all but the back panel was shown and that was helpful. The back panel was a bit difficult but a hair dryer seemed to help . All in all it was a good choice to do it myself as it was done quicker than waiting on a repair man.
