This deli drawer is for refrigerators.
Deli drawer holds meats, vegetables and snacks in the fresh food compartment of the refrigerator.
Follow the instructions in the owner's manual when installing this part.
$157.51
In Stock
Order within the next 12 hrs and your part ships today!
This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your...
$10.97
In Stock
Order within the next 12 hrs and your part ships today!
This part is the replacement water line or tube for your refrigerator. It is made of white plastic and is sold individually. This tube supplies water to the ice maker and water dispenser If your refri...
$24.51
In Stock
Order within the next 12 hrs and your part ships today!
Remove water filter and water filter holder. Removed cover on back of frig. Removed clip where water line connects to back of water filter. Took half inch wrench pushed in on water line lock to release line. Repeat at other end. Reverse steps to put on new line. Easy repair.
Shut off water supply. Disconnect main supply line. Remove rear lower panel on back of refrigerator. Remove all tubing clamps on back. Disconnect leaking tubing from water supply valve. Remove water filter and unscrew/remove water filter housing. Replace tubing - connect to water filter housing then to water supply valve. Reconnect filter housing and filter. Reinstall lower panel, then main water supply line, then all tubing clamps. Turn water back on and check for leaks after discarding several glasses of water to fill filter. Job complete!
1) Removed the screws from lower back plate 2) Removed the screws holding the plastic water lines in place (little plastic brackets - several of them) 3) Take a picture of how the tubing and what hose goes into what part - the 5/16" hose can go into 2 different spots - I didn't do this and I had to fix this 4) Pull out the hose "tabs" that lock the clamp into place (several) 5) Push in new hose 6) Put in clamp 7) I had to remove the filter on the inside of the fridge. Remove the filter, there is one screw that comes out, then you will have access to the hose clamps 8) Repeat for all the other hoses 9) Put the plate and brackets back into place (the picture really helps on how to orient and route the 3 different tubes 10) Test the water 11) Crack open a beer for a job well done
Super easy - take a picture! It will save you time!
