This kit includes 8 rubber feet and adhesive. This surface burner grate pad set is for ranges.
Surface burner grate pad set contains the four pads that attach to the bottom of the burner grate to p...
Sold Individually. These legs should be adjusted to make your appliance level on uneven flooring.
$9.82
In Stock
Questions And Answers for 79072903010
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Don
November 30, 2022
I can't get my big burner to ignite
For model number 79072903010
Hi Don, thank you for reaching out. You need to check the Burner Igniter and Orifice Holder, part number PS2368573, and Spark Ignition Switches, part number PS3409150, to fix the issue. We hope this helps! If you need help placing an order, customer service is open 7 days a week. Thanks again for your great question.
Repair was quite easy, as long as you have the instructions for removing the door. The screws that hold the bottom of the door to the fixed hinge are placed into the side of the hinge assembly after removal; this holds the door at a 45 degree angle for easy removal. After that, just place the door on a flat surface and dismantle the door from the inside. The inner glass is contained in a metal frame with another piece of glass; this frame comes apart easily using the clips in each side. The door assembles easily after the glass is replaced; just take your time and give yourself enough room to lay out the parts as you go. Good luck!
Turned power off at electrical panel. Pulled oven away from wall. Removed back cover (6 screws), then unplugged wires from old receptacle. I had to pull the squeeze clips backwards & break them to remove the old receptacle - couldn't squeeze them enough to remove them otherwise. The old receptacle came out through the inside of the oven, and the new one snapped in easily from inside the oven as well. Replaced wiring, installed new bulb, restored power & tested. Replaced back cover. Good time to vacuum under/behind where the oven usually lives before sliding it back to the wall.