All Installation Instructions for Kenmore Dishwasher 58714012414B

Spray arm came off, got melted

Snapped the new spray arm in place.
Works like new!

Parts Used:

Lower Spray Arm

James from ANDERSON, IN
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Spay arm came off hit the heater and burned a hold in the side

Easy just snapped on works going again like new

Parts Used:

Lower Spray Arm

marcus from NORMAN, OK
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Some of the silverware slip thru the silverware holder. During the drying cycle the exposed silverware was to close to the arm and melted an area of the arm which caused water to seep out onto the kitchen floor.

To remove the spray arm just squeeze the sides pull up and replace the new lower spray arm in it's place. Just push down.

Parts Used:

Lower Spray Arm

Gloria from Washington, DC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Our dishwasher spray arm got stuck on a rogue dish and melted on the heating element

The spray arm simply clips to a base in the center of the dishwasher tub. The repair takes 30 seconds - the lower rack slides out, twist the base of the old spray arm to lift it off, and snap the new one on.

Parts Used:

Lower Spray Arm

Mackenzie from MADISON, WI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Spray Arm melted easy replacement

Popped it in and done

Parts Used:

Lower Spray Arm

Amanda from HAYESVILLE, NC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

lower spray arm came off and melted on the header coil

took old one off by hand, snaped the new one in place by hand

Parts Used:

Lower Spray Arm

steve from PT CHARLOTTE, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Two of the tub wheels cracked and broke off.

Unscrewed the old ones, new ones come with screw built in and recrewed the new ones in. So easy.

Parts Used:

ROLLER ASSEMBLY

Sharon from HAMPTON, NH
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Dispenser failed to operate

Uncomplicated repair. Remove door, remove old dispenser, install new dispenser.

Parts Used:

Detergent Dispenser

GENE from BRONX, NY
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Missing part

Just pushed it onto the rod that held the old one

Parts Used:

Wheel & Bushing Assembly

Michael from STEWARTSVILLE, NJ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Plug for soap dispenser.

My future son in law did it. Looked at instructions on the app for the part. Didn't take very long.

Parts Used:

Detergent Dispenser

Janice from ELK GROVE, CA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Old gasket melted.

Watched installation video and followed directions. All went smoothly.

Parts Used:

Dishwasher Tub Gasket - Gray

Al from WOODBURY, MN
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Leaking tub seal

Just pulled the old gasket out and popped in the new. I did trim it too shrt however so be careful not to do that.

Parts Used:

Dishwasher Tub Gasket - Gray

Bob from Clinton, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Bottom seal on door came out and melted on heating element.

Took me about 2 minutes to repair, no tools to repair, very easy installation repair!

Parts Used:

Dishwasher Door Bottom Seal

Danny from Collierville, TN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Brass nuts holding heating element in place had split

All you have to do power down the unit, then disconnect the power connections at the element and remove the old nuts and replace them with the new ones and tighten. Don't tighten too much, the element has a rubber seal that just needs the nut to snug it up.

Parts Used: