This bottle of oil is OEM and approved by the manufacturer. It is compatible with dozens of models of pressure washers. This one 4.6 oz bottle is the adequate amount of oil needed for the machine. A s...
This is a genuine OEM sourced component which is specially designed for Craftsman pressure washers. It is an identical replacement for a missing or damaged outlet that was originally installed on a ne...
This is an authentic Briggs & Stratton replacement part manufactured for use with pressure washers. The seals are used with the brass head on the pump. This seal set kit is sold as an individual replacement part.
It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton generators and pressure washers. The purpose of this component is to reduce the...
This is an authentic OEM part for use with Craftsman Pressure Washers. The wand connects to the spray gun handle and houses the nozzle that directs the spray stream. The most common reasons for replac...
Pressure washer pump kit. If the pressure washer is leaking water, the pump may need to be rebuilt or replaced. If the pump is more than a few years old, and you use the pressure washer fairly often, replace the pump.
This genuine OEM sourced replacement part is designed for use with pressure washers. If the pressure washer runs too long with out the release of water from the sprayer, the water will heat up inside ...
This replacement trigger gun assembly is specially designed for use with a variety of pressure washers. It is the essential part of the unit that allows user to direct and control the spray. Please no...
$177.95
Special Order
Questions And Answers for 580767101
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
One can either pull off the plastic fitting on one end (the one with an o-ring) and press the plastic tubing onto the pressure washer detergent inlet (located just behind the high pressure hose outlet/connector). The other end of the device is then inserted into a jug of pressure washer detergent and the lowest pressure nozzle or nozzle setting selected to allow detergent to be drawn up into the washwater stream with the pressure washer running. One can observe the detergent flowing into the washer if all is good! If one cannot pull off the plastic fitting on one end (the other fitting, to be left!, has a "screen" on its end - the fitting can be cut off the plastic tubing with a utility knife.
The description of the parts package on your website did not appear to be in proper (size) scale However, after following a Youtube video, I was then able to decipher what parts went where to be sure I was ordering the correct parts that I needed. Parts were shipped promptly and I found that replacing just the check valve o rings and seats, it cured the problem without having to use the other parts that came with the kit package. Would definitely order from this site again. BL NC
