41798022000 Kenmore Dryer - Overview
Sections of the 41798022000
[Viewing 6 of 6]
Manuals & Care Guides for 41798022000
Click to downloadInstall
Installation Instructions
(1.99MB)
Care
Use and Care Manual
(4.21MB)
Wiring
Wiring Diagram
(0.26MB)
Keep searches simple, eg. "belt" or "pump".
Door Catch
PartSelect #: PS418433
Manufacturer #: 131658800
This part helps keep the door closed while the machine is running.
$75.04
In Stock
Order within the next 10 hrs and your part ships today!
Belt
PartSelect #: PS2349294
Manufacturer #: 134719300
If your dryer drum has stopped spinning and your clothes are coming out damp, it might be time to replace the belt. This essential part helps the drum rotate, allowing warm air to circulate and dry yo...
$84.00
In Stock
Order within the next 10 hrs and your part ships today!
Door Strike
PartSelect #: PS455020
Manufacturer #: 5303207102
"Male" piece of a dryer door closing mechanism.
$36.73
In Stock
Order within the next 10 hrs and your part ships today!
Adjustable Leveling Foot - Black
PartSelect #: PS425733
Manufacturer #: 216396900
Sold Individually.
$41.81
In Stock
Order within the next 10 hrs and your part ships today!
Blower Housing with Blower Wheel
PartSelect #: PS418726
Manufacturer #: 131775600
This blower wheel and housing assembly is a vital component in select electric and gas dryers, responsible for circulating air through the drum and out the exhaust. Made from durable white plastic, it...
$177.09
In Stock
Order within the next 10 hrs and your part ships today!
Control Thermistor
PartSelect #: PS1149368
Manufacturer #: 134587700
This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating. This part is located in the blower housing.
$69.02
In Stock
Order within the next 10 hrs and your part ships today!
M Series Ignition Coil Kit
PartSelect #: PS470049
Manufacturer #: 5303931775
This ignition coil kit contains two coils. One is a two wire secondary coil, while the other is a three wire booster coil. Both should be used together in your gas clothes dryer.
$43.95
In Stock
Order within the next 10 hrs and your part ships today!
Screw
PartSelect #: PS417463
Manufacturer #: 131302800
This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. T...
$28.95
In Stock
Order within the next 10 hrs and your part ships today!
GASKET
PartSelect #: PS8689127
Manufacturer #: 137553402
This is a gasket, but you may also know it as a door seal, for your dryer. This part prevents heat loss during a drying cycle by keeping the area around the door sealed. This gasket is all black, and ...
$101.60
In Stock
Order within the next 10 hrs and your part ships today!
Door Switch - 3 Wire
PartSelect #: PS2330880
Manufacturer #: 134813601
This switch is for a dryer door with a drum light.
$39.95
In Stock
Order within the next 10 hrs and your part ships today!
Thermal Fuse
PartSelect #: PS4704883
Manufacturer #: 134711401
This dryer thermal fuse is a critical safety component designed to protect the appliance from overheating. It automatically shuts off power to the motor or heating system if excessive temperatures are...
$44.34
In Stock
Order within the next 10 hrs and your part ships today!
Lint Filter - White
PartSelect #: PS2363394
Manufacturer #: 134701410
This dryer lint filter traps lint and debris from exhaust airflow to help prevent vent clogs and maintain efficient drying performance. It is typically located at the door opening or in a front-mounte...
$94.52
In Stock
Order within the next 10 hrs and your part ships today!
Common Symptoms of the 41798022000
[Viewing 7 of 7]Door won’t close
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Drum Not Spinning
Fixed by
these parts
these parts
Show All
Not Heating
Fixed by
these parts
these parts
Show All
Door Pops Open
Fixed by
these parts
these parts
Show All
Too hot
Fixed by
these parts
these parts
Show All
Won’t Start
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Dryer would heat initially then cool down
The top of the dryer was easily removed by prying the front up with a screwdriver then tipping it back and off of the mounting brackets. Then the front of the dryer was removed by unscrewing a single screw on each side that held the front to the side panels then pulling the front away from the dryer. Once the front was off, the coils were easily accessible on the bottom left side. A metal bracket held the coils on and was somewhat tough to get the two screws removed on it as they were stuck, but once they were removed the coils easily came out and I was able to replace them in minutes. The whole job took 15-20 minutes and I now have a dryer that heats through the entire drying cycle.
Parts Used:
-
Brett from Monticello, MN
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
99 of 112 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dryer would heat only on the initial start. Burner would not light again until completely cooled down. The ignitor would energize, but no gas would flow for ignition.
1. Pry Dryer top up and off the clips. (Front of Dryer)
2. Remove 2 phillips screws on the inside of front panel.
3. Lift front panel up and set off to the side
4. Removed 2 phillips screws with short handled phillips driver that hold the gas valve coil bracket in place.
5. Unplugged and removed both coils, installed new coils and bracket. Re installed front panel, screws and top.
2. Remove 2 phillips screws on the inside of front panel.
3. Lift front panel up and set off to the side
4. Removed 2 phillips screws with short handled phillips driver that hold the gas valve coil bracket in place.
5. Unplugged and removed both coils, installed new coils and bracket. Re installed front panel, screws and top.
Parts Used:
-
Bruce from Burnsville, MN
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
42 of 52 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door Latch & Door Strike Broken On Dryer
I removed the broken door latch & strike with pliers. Then I pushed the new parts into place
Parts Used:
-
Bruce from Seminole, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers
42 of 61 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!