This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Plier...
It is a genuine manufacturer-supplied item that is made for use with Briggs and Stratton engines that are commonly installed on a variety of lawn and garden equipment. This is a special liquid sealant...
This bottle of oil can be used in over 150 different types of machinery. It is most commonly used for pressure washers and generators from manufacturers such as Briggs and Stratton and Troy-Bilt. This...
This timing key is an OEM direct from Briggs & Stratton. The metal component is compatible with many small engines, and is sold individually. The key secures the shaft in the crankshaft. A wrench is o...
This is a genuine OEM sourced replacement exhaust gasket. It is specially made for use with Briggs and Stratton engines commonly used on Toro lawn and garden equipment. Its purpose is to provide an ai...
This is an authentic OEM sourced replacement part which is specially designed for use with lawn and garden equipment. The purpose of this part is to provide a tight seal between connected parts, over ...
This is an authentic OEM component from Briggs & Stratton. The magneto armature screw is compatible with many lawn and garden engines. The hardened metal screw helps to mount the magneto armature. A w...
This authentic item is supplied directly from the original equipment manufacturer for use with engines, outboard motors, portable generators, snowthrowers, and lawn mowers made by Briggs & Stratton an...
This is an original Briggs & Stratton replacement part. The piston lock pin is commonly found in small engines. This part is made of metal, and is used to hold the piston pin in place in the piston....
This valve spring is a genuine OEM Briggs & Stratton replacement used in small gasoline engines to maintain proper valve tension and timing during operation. It helps prevent valve float and ensures c...
Clean engine with a Gunk type product. Remove valve cover. Loosen bolts and remove old cylinder head. One bolt is located inside valve cover area. Remove old gasket and inspect and clean that surface. Attach new head with new gasket using existing bolts. Torque to 18'#s with a cross type pattern. Attach new rocker arms and push rods. Set valve clearance to .004 - .006. Attach valve cover with gasket. Check oil level. Start and let it warm up. Let cool remove cover then check valve clearance again. Replace cover.
Look on YouTube for video's on how to replace a Briggs governor. There are several there. My favorite, with best explanation, is, "Easily Replace Briggs Governor Gear (V-Twin Intek Engine) with Taryl". https://www.youtube.com/watch?v=wn3eanGxSEA&t=152s.
Taryl (probably not his real name) does a very good job of showing step-by-step the whole procedure, along with some additional hints/tricks/techniques of value.
Not including oil and filter, I spent less than $50 for a new governor, gasket, and drive shaft seal. That's all that is really necessary to replace is those three parts. That is, unless pieces of the old governor tore up a gear, valve, or something else. Inspect everything! {I was lucky and only the governor was destroyed}
One word of note. Be sure to clean out all of the debris from the blown governor. Be sure to remove the spark plugs and carefully rotate the drive shaft while looking for nooks-and-crannies where debris can hide. I tried to use a magnet to help, but it didn't help much, even though the block is aluminum.
pinged valve guide reinstalled head with new gasket inserted rods adjusted valve 15 min. later mowing lawn first time doin such repair note used magnet to pull old rod inside engine to drain left in rotated engine maling sure no parts broken started up and away i went c how long it lasts mower had over6500 hrs.. on it
