This flywheel puller is designed for servicing larger small engines by safely removing tightly seated flywheels without stressing the crankshaft or damaging ignition components. Constructed from heavy...
It is a genuine OEM item that is made for Briggs and Stratton engines that are commonly installed on a variety of lawn and garden equipment. This is a special component which helps to provide a tight ...
This authentic item is supplied directly from the original equipment manufacturer for use with engines, outboard motors, portable generators, snowthrowers, and lawn mowers made by Briggs & Stratton an...
The governor shaft seal is sold individually and is made out of plastic. A screwdriver, a set of pliers, and a socket set might all be needed during the installation of this item. Over time this part ...
This is an authentic OEM sourced replacement part which is specially designed for use with lawn and garden equipment. The purpose of this part is to provide a tight seal between connected parts, over ...
This is an authentic OEM component from Briggs & Stratton. The magneto armature screw is compatible with many lawn and garden engines. The hardened metal screw helps to mount the magneto armature. A w...
This is a genuine Briggs and Stratton part for use with lawn and garden equipment engines. The rocker arm opens the intake and exhaust valves. The most common reason for replacing the rocker arm is if...
This is an original replacement part sourced directly from the manufacturer. The control lever is commonly found in engines, generators, and pressure washers from Briggs & Stratton, and in lawn tract...
Removed head. Replaced both rocker arms, intake pus rod, push rod guide exhaust and head gaskets. Torqued head in 3 stages to 216 in/lbs. gapped intake to .004 and exhaust to .006 at TDC
Added oil and gas. Now running great
If you need to replace push rods use steel (exhaust) they are the same length The engine was a Briggs & Stratton 217802 0113 E10604 (2006 year date code) I used the following 796189 gasket 272475S gasket 697494 push rod 690822 push rod guide 691751 rocker arms
First I opened the top of the mower to expose the housing cover. Secondly I removed the four housing bolts to remove the housing cover from the mower. Next I removed the tube breather and installed the new tube breather and replaced the housing cover with the four bolts previously removed and closed the top of the mower. I filled the mower with gas to check for leaks which weren't any leaks. I proceeded to mow the lawn with ease.
