***No Conversion Kit Required - Adjust On Appliance***
This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.
Turned power off at electrical panel. Pulled oven away from wall. Removed back cover (6 screws), then unplugged wires from old receptacle. I had to pull the squeeze clips backwards & break them to remove the old receptacle - couldn't squeeze them enough to remove them otherwise. The old receptacle came out through the inside of the oven, and the new one snapped in easily from inside the oven as well. Replaced wiring, installed new bulb, restored power & tested. Replaced back cover. Good time to vacuum under/behind where the oven usually lives before sliding it back to the wall.
Remove decorative side panels on stove to expose backside of hinge and springs; remove door; remove old hardware; since hinge openings were bent, straighten hinge opening in oven face; attach spring to inside of oven; slide hinge through opening; attach spring to hinge; screw hinges to oven face; repeat on other side; attach hinges to door; while decorative panels are off, vacuum install decorative panels. DONE.
