Models > 25368892012 > Instructions

25368892012 Kenmore Refrigerator - Instructions

All Instructions for the 25368892012
31 - 45 of 496
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Freezer Freezing up and blocking the vent for refrigerator, not cooling the fridge.
Went pretty straight forward, except the heat shrink tubing was about 2 sizes too big. Would not shrink small enough to seal the connections. Even with a heat gun it would not shrink small enough. OH, another think is when I plugged the fridge back in the defrost timer was in defrost mode. Took me a few minutes to figure that out and use a screwdriver to turn the timer back to the on position. Other than that, install was pretty simple.
Parts Used:
Defrost Thermostat Defrost Timer - 120V 60Hz
  • Dennis from BEAUMONT, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Nutdriver
16 of 25 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Plastic Shelf Broke
Snapped in place in less than 30 seconds
Parts Used:
Refrigerator Door Shelf Bin
  • Jim from Carlsbad, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
11 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bottom shelf on door cracked and broke
I ordered the Door Shelf Bin from PartSelect.com on Friday and received it on Saturday!! I was shocked, but thrilled. The easy to use diagram helped me to pick the right part and I easily replaced the broken one. I have already started to recommend PartSelect.com I was so thrilled with their service!
Parts Used:
Refrigerator Door Shelf Bin
  • Jamie from Greensburg, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
12 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
gasket broken and old and shelves broken
the gasket simply pushed on and shelves went right in place
Parts Used:
Refrigerator Door Gasket Refrigerator Door Shelf Bin Refrigerator Door Shelf Retainer Bin
  • Rose from BATH SPRINGS, TN
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
15 of 24 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Coming from the refrigerator, there was an intermittent "clicking noise", occurring about every 30 seconds. The frig. eventually failed .
I removed the back cover and removed the clip holding the compressor- run capacitor and start relay. I replaced these 2 components and clean the dust from the frig., and from the bottom of the floor. I replaced the back cover ; Loss about $300 worth of meat when when the frig. failed. Then I thought that, during these turbulent times, there are many which don't have a refrigerator or any meat to place in it, The refrigerator is "running" normal again.
Parts Used:
Run Capacitor - 120V
  • winifred from LOUISVILLE, KY
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers
11 of 13 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
No shelf in Freezer compartment though obvious slots provided.
Used model # of frigidaire on your web site... reviewed parts available... noticed shelves abailable... zoomed in to measure using crosshatch background... measured my freezer compartment... seemed doable... ordered shelf... receivednext day... attempted to slip in slots... had to grind off 3/16th inch on two legs... slipped in... Perfect!
Parts Used:
Freezer Shelf
  • Joe from Dallas, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
10 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leaking Door Gasket
Open door remove old gasket, remove new one out of packaging install new gasket
Parts Used:
Refrigerator Door Gasket
  • Ulrich from Ontario, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
12 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
the rail broke on the meat drawer holder
I removed the shelf that hold's the rail's then one (1) screw that hold's the rail in place then I replaced the shelf. Simple & Easy!!
Parts Used:
Drawer Support Rail - Right Side
  • Geronimo from McAllen, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
10 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
refrigerator door would not fully close
Took old gasket off and put new gasket into place. Part came in the mail in 2 days. Hardest part was finding the model number of the refrigerator.
Parts Used:
Refrigerator Door Gasket
  • Elizabeth from Chicago, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
10 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Gaskets needed replacing
I watched u-tube and did the same thing. It was simple.
Parts Used:
Refrigerator Door Gasket Freezer Door Gasket
  • Claire Ellyn from Inverness, FL
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    15 - 30 mins
10 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The Gasket was not holding tight and I replaced with a new one.
Just like you showed on you tube.
Parts Used:
Refrigerator Door Gasket
  • Kebreab from NASHVILLE, TN
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    15 - 30 mins
9 of 10 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Crisper Pan
Just removed the broken pan and installed the new one within 2 minutes. Really simple
Parts Used:
Refrigerator Crisper Pan
  • Deepankar from Novi, MI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
13 of 22 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken meat drawer support
Took out the broken piece, replaced it with the new support using only a screwdriver, and VOILA, it was finished. Thanks!
Parts Used:
Drawer Support Rail - Left Side
  • Sue from Ocala, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
8 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken drawer support and drawer'
Drawer support held in by one screw drawer slide in no problem
Parts Used:
Meat Pan Drawer Support Rail - Right Side
  • Cameron from Bronx, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
9 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door Shelf Was borken held together by duck tape
I receive the part the next day eventhough I paid for 3-5 day delivery. It took lest than 10 seconds to snap into place and now it looks like new.
Parts Used:
Refrigerator Door Shelf Bin
  • Letitia from OFallon, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
9 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 25368892012
31 - 45 of 496
Back to Top