All Installation Instructions for Kenmore Refrigerator 25331840100

The door gasket was not working at all

I watched and followed the instructions on YouTube ?? very easy

Parts Used:

Refrigerator Door Gasket

Bobbie from ARLETA, CA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Shelves we're missing the bars to hold foods

Assembled the bar and ends, then slide into slots on door. Cross bars have tabs to lock in place. These tabs may need a little effort to get started.

Parts Used:

5A - Door Shelf Retainer Bar End Cap - Right Side

6A- Door Shelf Retainer Bar End Cap - Left Side

Door Shelf Retainer Bar - Cut to Fit

Door Shelf Retainer Bar End Cap - Right Side

Door Shelf Retainer Bar End Cap - Left Side

Cindy from Mallory,, WV
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Front upper edge of crisperpan was broken

Slid out old, broken pan and slid in new replacement pan.

Parts Used:

Refrigerator Crisper Pan

Richard from DAYTON, OH
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Right drawer rail broke/ don't need left

Screwdriver

Parts Used:

Drawer Support Rail - Left Side

Edward from FREEPORT, NY
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Refrigerator and freezer running to warm.

I watched the video on how to change the defrost thermostat. I removed the back cover inside the freezer then I pulled off the old defrost thermostat and then using a pair of wire cutters I cut it off and then bared a little of both of the wires and then slid the heat sherink and wire connectors on the existing wires and then slid the other ends of the wires into the wire connectors then crimped the ends of the connectors and then tried using heat on the heat shrinks but still used rubber electric tape over it. I clipped the new thermostat were the old one was and then reattached the freezer wall cover and plugged the refrigerator back in. 24 hours later I checked the temperature in the refrigerator and freezer and both are running a lot colder.

Parts Used:

Defrost Thermostat

Nathan from WELLS, ME
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Repaired Oven Range Light Bulb

The bulb has a plastic clear cover. That cover can just be carefully removed using a screwdriver. It's held in by a metal bracket. After you remove the cover. You'll just need to replace the bulb and then re-install the cover and bracket.

Parts Used:

Light Bulb

Alan from SAN MATEO, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Refrigerator door gasket was cracked along the top edge

Super easy fix! Used flathead screwdriver to start corner of gasket, then just pulled it out with my hands. Cleaned the track and surrounding area with a rag and some windex. Started in top right corner with new gasket and just worked my way around the door until it was fully seated in track. Done! Only thing I would do differently next time would be to start at the bottom when installing new gasket, just so I could have better sight and leverage at the end.

Parts Used:

Refrigerator Door Gasket

Carla from SALEM, VA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Broken support rail

First, I removed the screw holding the support rail and, because of using super glue to attempt a temporary fix, I had a little difficulty in removing it from it's location.

Since I have "tremors" next time email me a repairman.

Thank you.

Robert L. Enox

Parts Used:

Drawer Support Rail - Right Side

Robert from Duson, LA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

The fridge door had a broken bottom bar and everything fell off when you opened the door!

I just took off the broken piece and replaced it with the brand new piece I got from Partselect.com. The part was like three bucks and shipping was a little over 5. I fixed the bottom shelf for under ten bucks. I didn't think I'd be able to find the part on the net, but a quick google search led me here. My wife was always nagging me to fix it. The duct tape I used just wasn't good enough for her. Now, with partselect.com I made her dream come true! David Bueno-Hill

Parts Used:

Door Shelf Retainer Bar End Cap - Left Side

david from Los Angeles, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

bottom door seal won't seal right

R&R DOOR SEAL VERY EASY TO INSTALL THANKS TO ALL

Parts Used:

Refrigerator Door Gasket

MANUEL from LOS ANGELES, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

i smell very bad smell coming from refrigerator

I started look inside ,disconnected power, and open all possible compartments to see any burned part. Fortunately I fined a small part look like melted and then i went online and make my research .Then i ordered that part and change it.

Parts Used:

Defrost Thermostat