All Installation Instructions for Kenmore Refrigerator 25331670105

Door Would Not Close

I stuck a small screw driver under the old switch & it came out really easy. I just unplugged the 2 electrical connectors, and removed the old switch. Installing the new one was just as easy. I am a woman!

I also want to say how FAST PartSelect gets their items to you. It came in ONE day!

Your repair stories are very helpful, I/we would have never known how easy this switch was to replace! Thank you!

Parts Used:

Light Switch

Janice M. from Washington, DC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

light switch did not operate correctly

Piece of cake! The new part just plugged in to socket and back into fridge frame. Appreciated how easy it was to order this part.

Parts Used:

Light Switch

Jeff from Lakeville, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

5 of 9 people found this instruction helpful.

Was this instruction helpful to you?

Freezer icing up and refrigerator section not cold

Removed four screws for cover on refrigerator temperature controls, unpluged old timer and pluged in new timer. Replaced cover and screws.

Parts Used:

Defrost Timer - 60Hz 120V

Les from Fenton, MO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Top cools bottom is weak

Unplug, remove 2 screws off back panel inside the freezer. Cut wires on old one and crimped in new one. Light to melt the shrink wrap that came with it. Pretty easy.

Parts Used:

Defrost Thermostat

JUSTIN from NEW BRAUNFELS, TX
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Over a few days duration the ice maker stopped producing cubes , after a basic examination of the unit I found a web site that provided parts and instruction on self repair .

so basically if you can make toast , you can do this repair....loosen 2 hex head screws ,lift up on the ice maker and separate from wall of freezer , unplug the wire harness ,it is now OUT , swap the water level indicator to new part [30 second job ] Install the new part in reverse order as mentioned above... enjoy your ice

Parts Used:

Icemaker Assembly

Frank from IVYLAND, PA
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

After installing new ice maker water was not running into the ice maker.

Shut off water supply under the sink. Removed old valve and installed new valve. Turned water back on and within a couple hours the first batch of ice made.

Parts Used:

Water Inlet Valve

Leah from Tecumseh, OK
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers

5 of 9 people found this instruction helpful.

Was this instruction helpful to you?

Ice maker stopped making ice.

The repair was fast and easy .I removed the ice tray , disconnected the wiring connector and lossend two screws. I removed ice maker assy.and repeated in reverse order to install. I also installed a new water filter. I had ice in about 20 minutes.

Parts Used:

Refrigerator Ice Maker Assembly

Thomas from WESTAMPTON, NJ
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Drive great stripped for ice eject. Heater bad

Loosened the 2 bolts 4 turns where it mounts inside the freezer. Lift maker off the bolts unplug 1 plug. Reverse to install.

Parts Used:

Refrigerator Ice Maker Assembly

Danny from PUEBLO, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Crisper Drawer in Fridge was cracked

Ordered a new one and simply slid it into place

Parts Used:

Crisper Drawer

Linda from INVERNESS, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Freezer too cold

Removed the housing with the light, 4 hexhead screws. This exposed the defrost timer, removed 2 hexhead screws, electrical connector and reassembled the unit.

Great resource and service, thank you.

Parts Used:

Defrost Timer - 60Hz 120V

Curt from Maple Grove, MN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

I purchased a new frigh as a back-up downstairs that came with only two shelves. Since I wanted to used it for pop and beer, two more shelves would separate them well.

1.unpack box.
2. slide out of plastic bag.
3. open refirgheratior door.
4. slide in shelves.
5. fill with stuff.
6.figure out a way to reuse packing.

Parts Used:

Wire Shelf

David from Sioux Falls, SD
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

9 of 21 people found this instruction helpful.

Was this instruction helpful to you?

top shelf broke; replaced it

It just snaps in place, no biggie. What was a big deal was... that I ordered the part one day at like 2pm and got it the next day by about 2pm. That was very strange!!! Never expected that sort of delivery. Very nice!

Parts Used:

Door Rack

Kristy from Woodbridge, VA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

The refrigerator wasn't cold enough.

I removed the plastic shroud on the ceiling of the refigerator, unscrewed and unplugged the old defrost timer, and replaced it with the new one. I reinstalled the shroud with the new timer installed.

Parts Used:

Defrost Timer - 60Hz 120V

John from San Diego, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Ice maker would dump ice one time and then stop. Turning the ice maker off for a minute and back on would repeat the process.

I removed the two side mount screws with a screwdriver and disconnected the electrical plug to the ice maker to remove it. I reversed the process to install the new one.

It was the thermostat that was the problem, but I chose to replace the entire ice maker for only $25 more.

Parts Used:

Refrigerator Ice Maker Assembly