20122 (1988) Kenmore Range - Instructions

The removal of the old burner and installation of the new burners was easy. Just lift the opposite side that rests on the rim and pull burner out. New burner then gets inserted and the opposite side goes right into rim. It took all of 30 seconds to replace both burners. I wish I had replaced these when they first started to go!!

Pulled out element, plugged in new element. About 5 seconds.

Of course, power off first, then I removed the old one and inserted the new one, make sure everything in right place, then turn on power, simple as 1-2-3.

simply replaced them.

Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.

Installed easily, was most impressed with the speed of delivery and it was the perfect size!!

Ordered the part and set it in.

I ordered a new drip pan. Piece of cake. Stove looks new again.

Easy

I'm a female so first instinct was to hire this job out until I came looking for the part price. I followed other folks instruction, unplugging the stove, removed the holding screws [2] inside using a nut driver, being careful to not allow the wires to slip into the back wall of the stove, pulled the element forward and unfastened the wires from the bake unit. Inserted the wires onto the new unit, lifted the unit up a bit to get the correct angle to slide it all back in place, returned the holding screws to position, plugged the stove back in, turned it on and viola - an cheap, easy, satisfying repair job. Thank you for all of the tips. I saved over a hundred dollars and learned a skill.

the part arrived in two days. Just had to remove the old one and pop in the new one and it was that easy. I was amazed at how soon the part was delivered and happy to have a working burner again.

I ordered the 2 burners that were not working. When I got the burners, I discovered that one of the burners was still working and the wiring under that on had burned out. So I ordered the little box kit and repaired it. I only needed to strip wires and twist together and replace the small box. Now all are working and I am cooking with all four burners again. All for about $50.

Since it was a plug-in burner, only needed to pull it out and put the other one in.

Another thing I would like to say is that I was very well pleased with the service from partselect.com. I was unable to find the burners in my area.
Was very helpful in selecting the part and was very efficient in sending it.

extremely easy to replace the burner. I just pulled out the old burner and replaced with new one. The whole process took less than ten minutes.

Removed the old broken burner and slid the burner prongs into place. Very EASY to replace!