191431-0112-XX Briggs and Stratton Engine - Overview

Puller-flywheel This flywheel puller is designed for servicing larger small engines by safely removing tightly seated flywheels without stressing the crankshaft or damaging ignition components. Constructed from heavy... Add to cart

Bowl-fuel Filter Add to cart

Kit-idle Mixture This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. The idle mixture kit is used to adjust the amount of fuel that is sent to the engine's intake while the... Add to cart

Washer Add to cart

Spring-valve This authentic hardware is supplied by the original equipment manufacturer for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is the special spring utilized t... Add to cart

Lever-control This is an original replacement part sourced directly from the manufacturer. The control lever is commonly found in engines, generators, and pressure washers from Briggs & Stratton, and in lawn tract... Add to cart

Seal-o Ring This authentic manufacturer-supplied washer is specially designed for use with Briggs and Stratton engines that are commonly installed on lawn and garden equipment. It is a special hardware that helps... Add to cart

Key-drive Pulley This is a genuine OEM sourced replacement part that is intended to be used with snow throwers and lawn tractors from Briggs & Stratton and Toro. The key fits into the slot on the crankshaft and is use... Add to cart

Cap-oil Fill This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the t... Add to cart

Pin-Shaft Add to cart

Screw Add to cart

Gasket-intake Gasket-Intake Add to cart