130212-2196-01 Briggs and Stratton Engine - Overview
Sections of the 130212-2196-01
[Viewing 8 of 8]
Keep searches simple, eg. "belt" or "pump".
Gasket-crkcse/009
PartSelect #: PS8939396
Manufacturer #: 270126
This is a genuine Briggs & Stratton and Toro part sourced directly from the manufacturer for use in blowers, engines, generators, lawn tractors, and vacuums. The crankcase gasket is made out of a thin...
$14.95
Special Order
Filter-pre Cleaner
PartSelect #: PS8937831
Manufacturer #: 271466
This is an OEM approved replacement part designed for gas trimmers/brush cutters. Its purpose is to filter out dust and debris from the air that goes into the unit. Over time it will get dirty and clo...
$7.95
Special Order
Key-flywheel
PartSelect #: PS8925657
Manufacturer #: 222698S
This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Plier...
$5.95
In Stock
Order within the next 4 hrs and your part ships today!
Gasket-breather
PartSelect #: PS8943888
Manufacturer #: 27549S
This is the gasket that helps to provide an air tight seal for the breather assembly. It is a high quality item that is supplied by original equipment manufacturer for use with Briggs and Stratton and...
$6.95
Special Order
Common Symptoms of the 130212-2196-01
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
5 HP Briggs and Stratton chipper shredder - no spark
Removed old sparkless magneto, replaced with new part PS9278124 Magneto, and still no spark. The only conclusion that I can draw, is this magneto is defective,
Parts Used:
-
Thomas from ALFRED, ME
-
Difficulty Level:Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers
19 of 26 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replace fuel diaphragm, fuel pickup tube and air cleaner
This 5hp B&G was manufactured in 1985! Had been garage kept and always dependable. After 10 years of non use the carb wasn't getting gas. Removed air cleaner box, muffler and crankcase breather to easily remove carb, replace parts and reassemble.
Parts Used:
-
Gerald from MAULDIN, SC
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers, Socket set
7 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old diaphragm dried up
Tore carburetor off leaf blower and replaced. To do that require taking off the air cleaner removing the gas tank and all the brackets holding the controls on it. And keeping track of all the screws and Wires that control choke and throttle. I took several photographs. I did not need all the gaskets and jet’s that were included in the kit but it had what I needed.
Parts Used:
-
Steven C from CENTREVILLE, MI
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
6 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!