111P02-0113-F1 Briggs and Stratton Engine - Overview
Sections of the 111P02-0113-F1
[Viewing 10 of 10]-
Air Cleaner
-
Blower Housing CoverGuards Flywheel Rewind Starter
-
Camshaft Crankshaft Cylinder OperatorS Manual PistonRingsConnecting Rod Warning Label
-
Carburetor Carburetor Overhaul Kit
-
Controls Governor Spring Thermostat
-
Cylinder Head Gasket Set-Valves Valves
-
Electric Starter Ignition
-
Exhaust System
-
Fuel Supply Lubrication
-
Gasket Set-Engine Sump
Keep searches simple, eg. "belt" or "pump".
Key-flywheel
PartSelect #: PS8925657
Manufacturer #: 222698S
This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Plier...
$5.95
In Stock
Seal-oil
PartSelect #: PS8960670
Manufacturer #: 399781S
This is an authentic replacement part manufactured for use with small engines. Seals can deteriorate overtime, and it is recommended to replace worn seals when servicing an engine. This seal is the lo...
$13.95
Special Order
Engine Spark Plug Terminal
PartSelect #: PS8988266
Manufacturer #: 493880S
This spark plug terminal is supplied directly from the original equipment manufacturer. The metal terminal is designed to fasten the spark plug to the engine lead wire. This component is sold individu...
$5.95
Special Order
Filter-air Cleaner Ca
PartSelect #: PS9137508
Manufacturer #: 795066
This high quality replacement air cleaner cartridge is specially designed for use with Briggs and Stratton engines. It is an authentic OEM sourced item, not an aftermarket equivalent. It is utilized t...
$23.95
In Stock
Gasket-cylinder Head
PartSelect #: PS9152268
Manufacturer #: 796475
This is an authentic replacement part manufactured for use with small engines. The cylinder head gasket forms a seal between the cylinder head, and cylinder. It is recommended to replace gaskets when ...
$20.95
Special Order
Retainer-valve
PartSelect #: PS9074718
Manufacturer #: 692194
This is an authentic replacement part manufactured for use with Briggs & Stratton small engines. The special retainer is commonly used as spacing between the head of the valve and the valve spring. Th...
$10.95
Special Order
Rope-starter
PartSelect #: PS9077634
Manufacturer #: 697316
This manufacturer approved replacement part is a genuine starter rope. It is specially designed for use with small engines installed on lawn and garden equipment. This rope allow user to to crank star...
$10.95
Special Order
Plug-spark
PartSelect #: PS9074700
Manufacturer #: 692051
This item has been OEM sourced to ensure quality. The spark plug is intended to be used with outboard motors and lawnmower engines from Briggs & Stratton. The spark plug threads into the cylinder and ...
$9.95
In Stock
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Bought Troy Built pressure Washer at garage Sale for $30.00 leaked fuel
I have a solid understanding of small engines. This pressure washer was used twice in 2013, when purchased. Sat in a garage for a couple of years with gas in tank and carburetor. Owner was moving and after 7 years of moving it around he sold it at a garage sale.
I took it home and took off gas tank and thoroughly cleaned it. Then went through the carburetor and let soak in cleaner. Cleaned up the spark plug, tested and has good spark. reinstalled carburetor but would not start. I knew I had gas issues. I ordered a carburetor kit and replace the needle valve and seals. Still would not start. Ordered a new carburetor and spark plug. Installed both. Two pulls and it runs like new. Advice: don't try to clean out old carburetor, just buy a new one and install.
I took it home and took off gas tank and thoroughly cleaned it. Then went through the carburetor and let soak in cleaner. Cleaned up the spark plug, tested and has good spark. reinstalled carburetor but would not start. I knew I had gas issues. I ordered a carburetor kit and replace the needle valve and seals. Still would not start. Ordered a new carburetor and spark plug. Installed both. Two pulls and it runs like new. Advice: don't try to clean out old carburetor, just buy a new one and install.
Parts Used:
-
Laird from North Las Vegas, NV
-
Difficulty Level:Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Screw in new dipstick, check oil level
-
Kim from KENNER, LA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
5 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!