10661494401 Kenmore Refrigerator - Instructions

Michael from Colorado Springs, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

1 person found this instruction helpful.

Was this instruction helpful to you?

cracked crisper pan

slide out old pan, slide in new one.

Parts Used:

Refrigerator Crisper Pan

EUGENE from HACKENSACK, NJ
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Plugged it in.

Not so good that was not the problem. Fan is not seized and all the lights work and display is not on but lights up as well. No start once plugged back in after 15 minutes of being unplugged. Nothing same no change.

Parts Used:

Adam from GLOVERSVILLE, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

1 person found this instruction helpful.

Was this instruction helpful to you?

No cold

Like you video

Parts Used:

Jacqueline from LEXINGTON PK, MD
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers

1 person found this instruction helpful.

Was this instruction helpful to you?

Freezer occasionally had a temperature alarm.Clicking noise also.

Was told capacitor was problem 90% of the time.Capacior was not the problem.Bad start relay.

Parts Used:

Barry from FORD CITY, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Poor design leaves fitting vulnerable to damage. Part was broken when pushed to close to the wall.

Simply removed the old and replaced with the new part.

Parts Used:

Mike from Camas, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Movers broke the icemaker water fill tube shoving my refrigerator through the front door.

I unscrewed the fill tube screws from the back of the fridge, and pulled the tube out.

Then I put the new tube in, screwed the screws back in and reconnected the waterline.

Parts Used:

Christopher from Valley Village, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Light switch broke off

We looked up the problem online with the model number of the refrigerator. We ordered the part and followed the video installation that was sent with the order and was found online prior to purchasing

Parts Used:

Kathy from TEMECULA, CA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Water tubing was accidentally broken from the back of the freezer.

Removed the two screws holding the funnel in place...removed the old one and replaced it witht he new tubing...screwed screws back in and the jov was complete. It actually took longer to get it out of the sack than it did to put it together

Parts Used:

Lois from Thomasville, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

light did not work on the refrigerator side

bulbs were not burnt out. received the new switch in a few days. watch the short video, was good to see how it comes out. used a putty knife to release the defective switch, removed wires put them on the new one and posed the new switch back in. Not bad Part cost $11.00 7 dollars shipping so for 17 bucks it works great. nice to see what is inside the refer!

Parts Used:

David from GROVESPRING, MO
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Gasket was splitting

Had to remove both doors freezer and fresh section. Once I had door off removed the screws, and old gasket, cleaned all aroud where old gasket was, and proceeded to put new gasket on, It was hard lining up gasket with metal rods that hold gasket on could only do one screw at a time, because gasket kept slipping out, it was very time consuming.

Parts Used:

Fresh Food Door Gasket

Lawrence from Tishomingo, OK
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Socket set

2 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Rocker on switch broke off

Eased the putty knife under the edge of the switch housing and pried it off. Pulled two wires off the old terminals and hooked them onto the new one and reinstalled into the refrigerator body.

Parts Used:

David Barnes from ROSWELL, NM
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Old tube had cracked due to being frozen....

I followed the simple steps outlines in the great video! Thanks

Parts Used:

Stephen from Greensboro, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

1 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Light in my refrigerator didn't work.

At first I went to a local part supplier and they didn't have it in stock but could order it for me for $55.00 plus $10.00 to ship it. I told them I would have to think about it. I went home and got on the computer and found your web site and was I shocked when I saw the same part listed for $6.98 and $7.00 to ship it. You guys saved me $50.00. The part arrived in two day and took 5 min. to install. I now have light in my refrigerator. Thank you.

Parts Used: