092908-1433-99 Briggs and Stratton Engine - Overview
Sections of the 092908-1433-99
[Viewing 5 of 5]
Keep searches simple, eg. "belt" or "pump".
Filter-pre Cleaner
PartSelect #: PS8937831
Manufacturer #: 271466
This is an OEM approved replacement part designed for gas trimmers/brush cutters. Its purpose is to filter out dust and debris from the air that goes into the unit. Over time it will get dirty and clo...
$7.95
Special Order
Gasket-crkcse/009
PartSelect #: PS8937085
Manufacturer #: 270896
This is a genuine replacement part that is OEM sourced to be used with lawnmower engines from Briggs & Stratton and Toro. The gasket is used to seal the connection between the body of the crankcase an...
$10.95
Special Order
Seal-o Ring
PartSelect #: PS8936675
Manufacturer #: 270344S
This authentic OEM replacement part fits a variety of Toro and Briggs & Stratton engines. An O ring is used to retain pressure between rigid parts. Its flexible material allows it to create a tight se...
$5.95
In Stock
Order within the next 1 hr and 9 mins and your part ships today!
Spring-vert Rew Str
PartSelect #: PS8965473
Manufacturer #: 390066
Spring-Vert Rew Str
$36.95
Special Order
Seal-throttle Shaft
PartSelect #: PS8942061
Manufacturer #: 270167
This is an authentic Briggs & Stratton replacement part. The throttle shaft seal is commonly found in small engines, such as those used for yard equipment. This part is made of felt, and is used to ...
$8.95
Special Order
Common Symptoms of the 092908-1433-99
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Could not keep an aftermarket muffler on the engine.
Once I determined what OEM muffler I needed, installation was relatively easy. I have a 1982 4hp Briggs on my Snapper tiller. There was a 90* galvanized elbow coming out of the exhaust port, with a bezel nut to lock it down. Do not remove the elbow, even though it appears that you should. If you install the muffler without the elbow the muffler will parallel the the vacuum for the carburetor and can melt the rubber couplers. Use the elbow to direct the heat away from the carburetor. Use a pipe wrench to lock down the bezel nut because the weight of the muffler, especially under vibration, can work loose and fall down on the tine belt cover and melt it. The bezel nut that comes with the muffler should also be used to lock down the muffler to the threaded intake bracket that comes with the muffler, not to replace the bezel nut for the elbow.
Parts Used:
-
Richard from KERNERSVILLE, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Wrench set
13 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Muffler rusted out
-
Snoopy from TYRONE, GA
-
Difficulty Level:Very Easy
-
Total Repair Time:30 - 60 mins
7 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!