090102-0126-01 Briggs and Stratton Engine - Overview
Sections of the 090102-0126-01
[Viewing 10 of 10]
Keep searches simple, eg. "belt" or "pump".
Deflector-muffler
PartSelect #: PS8960984
Manufacturer #: 393760
This is a genuine Briggs & Stratton and Toro replacement part for use in engines, lawn mowers, and lawn tractors. The muffler deflector is made out of metal. A wrench may be needed during the replacem...
$15.95
Special Order
Filter-a/c Foam
PartSelect #: PS9274314
Manufacturer #: 272235S
It is a genuine OEM supplied replacement part that is produced for Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. This is the foam air cleaner filter that h...
$10.95
Special Order
Screw
PartSelect #: PS9294500
Manufacturer #: 690661
The metal screw attaches to the muff guard bracket. It is a genuine replacement part sourced from the original manufacturer for use with blowers, engines, generators, pressure washers, snowblowers, an...
$5.95
Special Order
Gasket-exhaust
PartSelect #: PS9294632
Manufacturer #: 691314
This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with small engines. The gasket is used to seal the connection between the muffle...
$10.95
Special Order
Filter-a/c Foam
PartSelect #: PS8941642
Manufacturer #: 27987S
This air cleaner element is supplied from original manufacturer. It is specially designed for use with Briggs and Stratton engines used on lawn and garden equipment. It is used to filter out dust from...
No Longer Available
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Could not keep an aftermarket muffler on the engine.
Once I determined what OEM muffler I needed, installation was relatively easy. I have a 1982 4hp Briggs on my Snapper tiller. There was a 90* galvanized elbow coming out of the exhaust port, with a bezel nut to lock it down. Do not remove the elbow, even though it appears that you should. If you install the muffler without the elbow the muffler will parallel the the vacuum for the carburetor and can melt the rubber couplers. Use the elbow to direct the heat away from the carburetor. Use a pipe wrench to lock down the bezel nut because the weight of the muffler, especially under vibration, can work loose and fall down on the tine belt cover and melt it. The bezel nut that comes with the muffler should also be used to lock down the muffler to the threaded intake bracket that comes with the muffler, not to replace the bezel nut for the elbow.
Parts Used:
-
Richard from KERNERSVILLE, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Wrench set
15 of 20 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!