080232-1834-01 Briggs and Stratton Engine - Overview
Sections of the 080232-1834-01
[Viewing 5 of 5]
Keep searches simple, eg. "belt" or "pump".
Filter-pre Cleaner
PartSelect #: PS8937831
Manufacturer #: 271466
This is an OEM approved replacement part designed for gas trimmers/brush cutters. Its purpose is to filter out dust and debris from the air that goes into the unit. Over time it will get dirty and clo...
$7.95
Special Order
Key-flywheel
PartSelect #: PS8925657
Manufacturer #: 222698S
This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Plier...
$5.95
In Stock
Gasket-intake
PartSelect #: PS8941014
Manufacturer #: 27355S
This is an authentic manufacturer sourced replacement part designed for use with a variety of lawn and garden equipment. This carburetor intake gasket which provides an air tight seal for the carburet...
$6.95
Special Order
Seal-throttle Shaft
PartSelect #: PS8942061
Manufacturer #: 270167
This is an authentic Briggs & Stratton replacement part. The throttle shaft seal is commonly found in small engines, such as those used for yard equipment. This part is made of felt, and is used to ...
$8.95
Special Order
Gasket-fuel Tank
PartSelect #: PS8943841
Manufacturer #: 272409S
This is a Genuine Manufacturer Sourced replacement part used on a variety of Engines. This part provides an air tight seal for mounting the Gas Tank. This part is made out of Composite Material and it...
$6.95
Special Order
Gasket-crkcse/009
PartSelect #: PS8937085
Manufacturer #: 270896
This is a genuine replacement part that is OEM sourced to be used with lawnmower engines from Briggs & Stratton and Toro. The gasket is used to seal the connection between the body of the crankcase an...
$10.95
Special Order
Cap-oil Fill
PartSelect #: PS8945667
Manufacturer #: 281658S
This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the t...
$7.95
Special Order
Common Symptoms of the 080232-1834-01
[Viewing 1 of 1]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Replace fuel diaphragm, fuel pickup tube and air cleaner
This 5hp B&G was manufactured in 1985! Had been garage kept and always dependable. After 10 years of non use the carb wasn't getting gas. Removed air cleaner box, muffler and crankcase breather to easily remove carb, replace parts and reassemble.
Parts Used:
-
Gerald from MAULDIN, SC
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers, Socket set
7 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old diaphragm dried up
Tore carburetor off leaf blower and replaced. To do that require taking off the air cleaner removing the gas tank and all the brackets holding the controls on it. And keeping track of all the screws and Wires that control choke and throttle. I took several photographs. I did not need all the gaskets and jet’s that were included in the kit but it had what I needed.
Parts Used:
-
Steven C from CENTREVILLE, MI
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
6 of 9 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!