This is a genuine replacement part that is OEM sourced to be used with lawnmower engines from Briggs & Stratton and Toro. The gasket is used to seal the connection between the body of the crankcase an...
This is an OEM approved replacement part designed for gas trimmers/brush cutters. Its purpose is to filter out dust and debris from the air that goes into the unit. Over time it will get dirty and clo...
This is an authentic manufacturer sourced replacement part designed for use with a variety of lawn and garden equipment. This carburetor intake gasket which provides an air tight seal for the carburet...
This is an authentic Briggs & Stratton replacement part. The throttle shaft seal is commonly found in small engines, such as those used for yard equipment. This part is made of felt, and is used to ...
This is an authentic OEM component from Briggs & Stratton. The magneto armature screw is compatible with many lawn and garden engines. The hardened metal screw helps to mount the magneto armature. A w...
This control rod clip is a genuine OEM replacement designed for small engine throttle linkages. It secures the control rod in place to help maintain consistent throttle response and stable engine spee...
This is an authentic manufacturer-sourced replacement part which is specially made for use with Briggs and Stratton engines that are commonly installed on Toro lawn and garden equipment. It is a stand...
This genuine manufacturer-sourced replacement part which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is a standard hardware which...
$6.95
Special Order
Questions And Answers for 060101-9401-13
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Once I determined what OEM muffler I needed, installation was relatively easy. I have a 1982 4hp Briggs on my Snapper tiller. There was a 90* galvanized elbow coming out of the exhaust port, with a bezel nut to lock it down. Do not remove the elbow, even though it appears that you should. If you install the muffler without the elbow the muffler will parallel the the vacuum for the carburetor and can melt the rubber couplers. Use the elbow to direct the heat away from the carburetor. Use a pipe wrench to lock down the bezel nut because the weight of the muffler, especially under vibration, can work loose and fall down on the tine belt cover and melt it. The bezel nut that comes with the muffler should also be used to lock down the muffler to the threaded intake bracket that comes with the muffler, not to replace the bezel nut for the elbow.
