Inglis Dryer Hardware

Roller Support Tri-Ring

★★★★★

★★★★★

3 Reviews

If you notice that your dryer is noisy or will not tumble, you may need to replace the tri ring. This part is triangular, and is less than an inch in size. Tri rings can be found both on the idler pulley shaft, or on the rear drum roller shaft. In either case, you will need to remove the front panel of the dryer and the drum to access the part for repair. Once you have accessed the damaged tri ring, you will simply need to slip it off and replace it with the new one. This part is sold individually. Be sure to disconnect the power source from the dryer before you begin this repair.

Igniter Kit

★★★★★

★★★★★

9 Reviews

This silicone carbide igniter with ceramic holder kit includes the 3" flat igniter, bracket, 4" wire leads, and the plug. It can replace both round and flat igniters. This kit is used for many gas clothes dryers.

Single Front Panel Cip This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel on to the dryer. If the clip is damaged or missing, or if the front panel appears loose, you may need to replace the clip. This part is sold individually and is an authentic OEM part.

Screw - 10-16 x 1

★★★★★

★★★★★

1 Review

This screw is sold individually.

Thrust Washer This washer is 3/4 inches in diameter.

Cover Screw Sold individually.

Knob Spring-Clip

★★★★★

★★★★★

1 Review

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Screw, 8/18 x 3/8 This screw is sold individually.

Roller Shaft Washer

Screw Metallic screw that is less than an inch long. Does not include the plastic washer.