Hotpoint Washer Parts

This easy-to-use white knob helps you control your GE washing machine’s settings like cycle time and temperature. If your current knob is cracked or loose, this replacement makes it simple to get your washer working like new again. Just pop the old one off and press the new one on—it’s a quick fix that brings back smooth, reliable control.

This does not come with the fabric dispenser - must order separately or use original part.

This drain hose is a replacement part for your top-loading washer. The hose measures 57 inches in length.

This knob accepts a D-shaped shaft.

The main tub seal is located between the transmission and the outer tub. It's the primary water seal in the outer tub for the transmission-shaft. This seal is difficult to replace and should probably be installed by a qualified technician.

This replacement drain pump is designed to efficiently remove water from your washing machine during the draining cycle. Encased in durable gray plastic, it measures approximately 9 inches in height, 6 inches in length, and 4 inches in thickness. If your washer isn’t draining properly, is leaking, or the pump isn’t spinning, this component may need to be replaced. Installation typically requires basic tools such as a screwdriver and wrench. Always disconnect power before beginning any repair.

This part is a replacement control knob for your washer. The control knob allows you to select the desired setting for your wash cycle. If your washer will not start or the timer will not advance, you may need to replace the control knob. Occasionally the control knob will become worn, and when this happens the control knob dial will not turn, and you will not be able to select the appropriate setting. If your control knob is worn, broken, or missing, you will need to replace it. The control knob is made of white plastic and is approximately 2 inches in diameter. The control knob is sold separately from the control knob dial, so be sure to confirm which part you need to complete your repair.

This tub bearing goes in your washing machine. You will find it on the bottom of the outer tub, where the transmission goes through the tub. If you hear metal on metal when the washer is spinning, you may need to replace the tub bearing. This bearing is made of metal, and is approximately 3 inches wide and 2 inches tall.

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.

This is a washing machine agitator coupling kit. It connects the transmission drive shaft to the agitator base. It includes the couple, gasket, and bolt.