3rd Level Wash Spinner Kit 8193768

Carefully unscrewed the top screw holding the spray arm so it doesn't fall into the tub.

Pull down the arm gently and pop out any remaining parts from the old spinner.

While the spray arm is pulled down, snap the two parts of the spinner together: one from above the spray arm, and one from below the spray arm. (you need to snap them together before you screw the spray arm back, because it won't snap together otherwise.)

Rescrew the spray arm and you are done.

First I removed the screw from the top water tube and then the upper screw from the vertical water tube at the back of the dishwasher. That gave enough flex to the tube assembly for access to the area I needed to get to, without having to remove it. Then I removed the old spinner retainer and installed the new one. I then snapped the spinner to the new retainer pin, put the tube back into position, and re-installed the screws -- and I was done.

Bent the plastic housing down holding the spinner. Slipped the top of clip in slot on top of housing. Attached spinner and bottom of clip by holding top clip and pushing bottom of clip in place. No tools were needed.

The part snaps on using two plastic retainers (included). You have to pull down gently on the feed tube at the top of the dishwasher to set the top retainer. After that it's a piece of cake.

Loosened 1 screw to access spinner button. Removed broken spinner button, replaced it with new button,snapped spinner and wedge on button ,replaced screw and was done in about 2 minutes. Thanks for the pictures of installation and the quick shipping of parts. Not to mention the money saved by doing it without a repairman. Thank you

It is possible to replace the 3rd level wash spinner by removing two retaining screws holding the plastic water passage inside the dishwasher. One screw is on the back wall and the other on the ceiling. It is advisable to place a towel over the bottom of the tub to prevent dropping the screws inside the bottom grinding chamber. The plastic water passage can be gently bent downward to complete the repair. Insert the plastic bearing into the spinner from the bottom side of water passage and press the plastic retaining pin into the plastic bearing from the top side. You will hear an audible click when the retaining pin is fully pressed into the plastic bearing. Replace the removed screws to complete the repair.

removed one screw holding the water tube up; gently pulled tube down to access male plug; removed worn plug, inserted new plug; snapped spinner and female plug from the bottom; replaced water tube screw.

It honestly took more time to take the dishwasher baskets out than the actual repair. Once the baskets were out, I put a piece of newspaper over the lower drain in case I dropped a part or the screw. I removed the top screw to access the broken part, removed it, and installed the new spinner. I put the screw back in and 2 minutes later, the dishwasher was in use once again.

Too easy!

Using past posts, this easy fix only required to bend down the plastic water ducting at the top of the dishwasher, and snap in the upper button to the lower button, which holds the spinner. I put newspaper down on the bootm of the dishwasher, in case I dropped the small plastic pieces.

There is a button that connects the spinner. It wore out, and the spinner fell into the top rack after a use of a cycle one day. Your diagram of the dishwasher was very helpful to understand what part to order. Your delivery was swift, and we only had to hand wash dishes for three days. Thank you for your excellent web page design and service. I will use your company again!