Secondary Dual Water Inlet Valve

Hello Ted, Thank you for your inquiry. You could have an issue with the ice maker side of the dual water inlet valve, or an issue with the ice maker. We have included a link to our video on how to test the water inlet valve with a multimeter, and how to test the ice maker for any issues. We also recommend checking the tubes for any clogs or damage. We hope this helps and if you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hi Cliff, Thank you for your question. The water inlet valve is usually located in the back of the refrigerator on the right hand side near the bottom. I hope this helps. Thank you and have a great day!

Hello Krist, Thank you for your inquiry. This part is the water inlet valve that supplies both the ice maker and water dispenser in the upper section. PS8690734 would be the water inlet valve that supplies the lower ice maker. We hope this helps you.

Hello Charles, thank you for your question. If the part that is leaking is the 90 degree coupling on the valve itself, its likely that the inside of that coupling is cracked or not sealing properly. Try to remove the tube and reinsert the tube to see if you can get back a good seal around that tube. If there are no holes or cracks in the tube, and the leak continues, you would want to replace that water valve. I hope this helps!

Hello Klaus, Thank you for your inquiry. For this particular part, we show that it has been redesigned by the manufacturer so that the water tubes should just insert into the fittings on the valve (you need to remove the clips underneath the fittings). Good luck with your repair.

Hello Shelly, thank you for a very interesting question. The issue is with the water inlet valve. We recommend you replace the water inlet valve, part number PS6883668, to fix the issue. We hope this solves your problem!

Hello Philip, thank you for reaching out to PartSelect. Yes, it sounds like the issue is most probably with a water inlet valve, part number PS6011774. We hope this information helps!

Hi Paul, thank you for reaching out. The dual water inlet valve is located on the left side door of the refrigerator inside the panel. We have found relevant instructions to access the dual water inlet valve. These may not be of the same model but will help you to access it. You may need to follow these steps: 1. Lift the door bin up and out. 2. Remove the screws holding the panel in place using a driver. 3. Pull the panel away from the door. 4. Remove the waterline clips using a plier. 5. To remove the water lines, press the tabs in on the valves while pulling out on the water lines. 6. Depress the locking tab on the dispenser refrigerator housing. 7. Slide the valve to the left, then out. We hope this information helps!

Hello Shawn, thank you for reaching out. We have researched and found that you may need to follow these instructions in order to reconnect the dual water inlet valve. These instructions may not be of the same model but will help you with the process: 1. Insert the tab on the left side of the valve into the dispenser housing, then press the valve back into the retaining slot until it locks into place. 2. Insert the water lines until they bottom out, then slightly pull back to make sure it is locked in place. 3. Install the clips and reconnect the electrical connector. 4. Align the cover, reinstall the screws and set the door bin back in place. We hope this helps!

Hello Greg, thank you for writing. This could be due to a faulty Water Valve Assembly, part number PS6883668 for your model. You may also want to consider the Water Filter, part number PS10063209. Good luck with your repair!