Pump Assembly Drain 5859EA1004J

Unplug washer , shut off water supply, remove water supply line, remove drain line from pipe, Unscrew 4 Philip head screws and gently bend panel enough to lift and remove. Beware of sharp edges. The hoses on the pump are hard to remove so remove the three # 10 MM bolts from the pump base and then squeeze the hose clamps and move them back away from the pump. Use a pair of channel lock pliers and hold the hose while twisting the pump motor this should loosen the hose enough to remove the hose. Do not remove the plug wires on the pump, unplug at the wire harness in the plastic bag on the side of the machine. your new pump should come with a new wire harness already plugged into the pump. Just swap it out with the old one Be careful not to pry the blue connector apart just press down on the little pin in the center of the connector and it just slides out. Note how the wire harness was routed and held in with the supports.
When reinstalling the three bolts do not over tighten. Reattach the hoses and the compression clamps. Reinstall the back panel make sure the instruction label faces out and the vents are on the top. reconnect the drain line to the pipe and reconnect the supply hoses Make sure Hot and old are correct., Plug machine in and run with the towels you used to mop up the water through a wash cycle and check for leaks.