Average Repair Rating: 2.5 / 5.0, 2 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
The dryer drum turned ok, but the gas heat did not start.
First I found and watched three videos on how to open the dryer and replace the igniter. Then I opened the dryer, but I did not remove the belt as suggested in the video, and then I removed the ignitor and flame detecter as the videos had shown. I got on-line and ordered the new parts from PartsSelect in the afternoon and had them in my hands the next morning by 9:30 am. I installed the new parts and everything worked fine again. You must be very careful with the igniter to not touch it with hands or anything else. I practiced puting in the old parts first.
Gas dryer was not getting hot and smelled like gas inside drum
Removed lower front panel and then front including door (need to remove the top to access screws.) Replaced both the ingiter and heat detector. The tricky part was getting access to the long tunnel-like bracket that houses the igniter. Washer and Dryer are in a tight cutout space in very small laundry room.
Ask our experts a question about this part and we'll get back to you as soon as possible!
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Wanda
July 31, 2019
Dryer squeals each load, and have to run loads through twice the normal cycle to dry completely.
For model number GTDP740GD0WW
Hi Wanda, thank you for your question. You may want to look at your rollers, idler arm, and your motor for being the issue. It sounds like they may either need to be changed because your drum may not be spinning as fast as it needs to be. I would suggest checking your pulley and rollers first. Good luck with your repair.
Was this helpful?
Thank you for voting!
Michael
November 28, 2023
GAS DRYER RUNS BUT NOT HEATING. REPLACED IGNITER AND CHECKED ALL THERMOSTATS AND FUSES FOR CONTINUITY ETC.ALL ARE TESTING OK. CLEANED OUT LINT ETC, PUT BACK TOGETHER STILL NO HEAT . PLEASE HELP
For model number GTD42GASJ2WW
Hi Michael, thank you for reaching out. Based on the description, the issue is probably with flame sensor, part number PS268031. The flame sensor monitors whether the igniter is hot enough to ignite gas to light the burner. We would suggest checking the sensor to fix the issue. We hope this helps.
Was this helpful?
Thank you for voting!
Joaquin
January 18, 2025
Our dryer no longer auto shuts off when the clothes are dry. I figure there is some sort of sensor or thermostat on this older model GE Dryer. Searched the parts list but didn't find anything. Was wondering if you could point me in the right direction. Which part and where in the dryer it is located would be great. Thanks.
For model number DPSR405GA0WW
Hello Joaquin, thank you for reaching out. Based on our understanding of the issue, we would suggest checking the moisture sensor to solve the problem. The moisture sensor bars for your model do not come separately and they come as a part of the lint chute assembly, part number PS11763093. We would recommend replacing it to solve the problem. Glad to be of help!
Was this helpful?
Thank you for voting!
Brent
February 13, 2025
i can see the dry glowing, it heat up a little bit and takes twice as long to dry clothes.
For model number GTD33GASK0WW
Hi Brent,
Thank you for your question. If it takes too long for your dryer to dry your clothes, we recommend checking the lint filter, the lint filter duct, the exhaust tube, and the exterior vent for lint build up. If these parts have a build up of lint in them, they will need to be thoroughly cleaned as a build up of lint can prevent air circulation. Also check the blower wheel to ensure it is firmly attached to the shaft. Inspect the blower wheel, and it’s housing, for any signs of wear or damage. You should also remove any foreign objects you may find near the blower wheel. If you find any signs of wear or damage, you will need a replacement blower wheel. We hope this helps!
This part is the replacement main valve coil for your dryer. It is black and white in color and has 2 terminals. It is approximately 1 inch long and 1 inch wide. The main valve coil opens the gas valves while the dryer i...
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
Having a problem with a funky-smelling washing machine, or one that just doesn't seem to clean your clothes as well as it used to? Say hello to the Affresh Washing Machine Cleaner by Whirlpool. This powerful washing help...
Affresh dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up that can be unsightly and could affect your dishwasher's performance. Each tablet is designed to clean inside your machine ...
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
