This gas oven safety valve ensures that no gas is released until the igniter has received the proper voltage needed to ignite the gas range.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part fixes the following symptoms:
Gas igniter glows | but will not light | Will Not Start | Little to no heat when baking
This part works with the following products:
Range.
This part works with the following products:
General Electric.
Part# WB19K31 replaces these:
AP2022762, 247066, WB19K31, 183D5746G001
Customer Repair Stories
Average Repair Rating: 4.4 / 5.0, 3 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Oven not getting hot/no flame no gas.
Step 1. Pull oven out disconnect power,turn off gas & remove gas line from stove. Step 2. Remove broiler drawer,locate igniter & safety valve. Step 3. Disconnect 2pin molex connector for igniter and faston connectors from valve. Step 4. Use nut driver remove fasteners that hold igniter and valve remove gas line and feed from valve. Step 5. Replace valve and igniter.Repeat steps 4-1 and start baking.
Note: You may only need a igniter and not a valve,both were bad on my unit. Most often it's just the igniter that goes out.
Take the advice that it's the igniter. Even thought the igniter lights, it doesn't mean it passes the correct current to the valve. Too much or too little won't work. I'd suggest changing the igniter first. I used to be in the valve business, that kind of valve lasts millions of cycles. The igniters on the other hand break down after a5-10 years
Other Parts Used:
Paul from San Diego, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers, Wrench (Adjustable)
36 of 40 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Oven would not light
I found the best was to remove the oven door and the broiller drawer. Then I removed the panel that seperates the two areas. This gave me great access. Next I removed the shield (1 screw) and the burner (3 screws). Then the inlet pipe (don't forget to turn off the gas, as I did). Remove the valve (2 screws)...........Remove the mounting bracket from old valve and install it on the new one. Then it's just a matter of reversing the prior steps and your'e done!
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
15 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Ramon
November 19, 2017
I need to convert my stove from natural gas to propane do you have the conversion kid and what is the price?
For model number RGB524PEA6WH
Hi Ramon,
Thank you for your question. I have attached the kit that you are looking for in a link down below. Good luck with your repair.
3 people found this helpful.
Was this helpful?
Thank you for voting!
Brent
November 20, 2017
Gas stovetop works fine, "glow plug" glows hot red but no smell of gas. Can we conclude that it is in fact the oven safety valve? Thank you
Hi Brent,
Thank you for your inquiry. The oven safety valve is one part that may fix the issue, but there are some other parts that you will need to check to see which one is causing the issue. You will need to check the igniter, the electronic control board and the temperature sensor. I hope this helps. Thank you and have a great day!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Krisha
December 6, 2017
Can this oven valve work on my range? The range was plugged into the wrong outlet and it shorted out, the igniter glows when the stove is turned on however the burner isn't lighting. I was told the the valve needs to be replaced.
For model number JGBP79BEB6BB
Hi Krisha,
Thank you for your question. This is not the correct safety valve for your appliance. I have listed the correct valve below for you. I hope that helps. Good luck with your repair.
Hello Ora, Thank you for your inquiry. The oven igniter for this model is part# WB2X9154. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
RODNEY
January 17, 2018
Will this part work for lp gas
For model number RGB508PEH4WH
Hi Rodney,
Thank you for your question. Yes, this part will work for propane. Please consult your owner's manual for further information. I hope this helps. Thank you and have a great day!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Curt
February 16, 2018
Oven doesn't heat. Igniter glows when gas is turned on, voltage on value starts near zero and slowly ramps up to just under 3 volts, but gas never ignites. The slow ramp seems normal to allow igniter to get hot, but not sure what the valve's voltage should be to have it open. Valve coil is not open per ohm meter. Sounds like a bad valve? Thanks.
For model number JGBS23WEA4WW
Hello Curt, Thank you for your inquiry. It sounds like it could be either this part or the pressure regulator. When the ignitor heats up to a certain temperature, it is supposed to trigger the valve to open and let the gas in to ignite and the regulator cuts it off at a certain pressure. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Sal
November 26, 2018
Is there any way to checkgas safety valve bench check
Hello Sal, thank you for your question. You can test the gas valve to see if it has gone bad. You will need to test this with a multimeter. Here is a video that will show you how to test that valve.
https://www.youtube.com/watch?v=-RZtxSvOe-U
I hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Steve
December 3, 2018
This stove is all ready converted to lp so this should work? Upper burner work just stove doesn't. Getting no lp gas to come thru. Thanks
For model number JGBS22BEA2AD
Hello Steve, thank you for your question. The oven safety valve part number WB19K31 will work with either NAT or LP gas. The part itself can be switched over without any additional parts. Please check your owners manual on steps to change that over. I hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Robert
June 12, 2019
In the oven a wire from the igniter shorted (had to pry the wire off the wall) to the frame. Would the control valve or the thermostat also be damaged. Where is the thermostat located on the stove. I noticed that the plastic on one of the knife connection on the control valve was missing
For model number JGBS23BEA2WH
Hello Robert, thank you for writing. It is doubtful that the Oven Safety Valve or Oven Thermostat were also damaged when this occurred. The Oven Thermostat (part PS235170 on your model) is located behind the Manifold Panel (control panel). We hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Morgan
October 1, 2019
Hi there, i have a GE gas range (model jgbp28sem1ss) and need to replace the safety valve for the part of the oven that bakes. Is this the correct part? Thanks
For model number JGBP28SEM1SS
Hello Morgan, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number: PS2370035. Hope this helps!
The flat-style oven igniter lights the gas burner in your oven. It includes a mounting bracket, two ceramic wire connectors, and measures 3-3/4 inches long. The plug may need to be spliced to the range wiring. Always unp...
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
Having a problem with a funky-smelling washing machine, or one that just doesnt seem to clean your clothes as well as it used to? Say hello to the Affresh Washing Machine Cleaner by Whirlpool. This powerful washing helpe...
Affresh dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up that can be unsightly and could affect your dishwasher's performance. Each tablet is designed to clean inside your machine ...
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
