WATER INLET 11030996

Hi Steve, thank you for the question. The gasket is located on the exterior of the cabinet wall under the cover. We hope that helps!

Hello Bruce, thank you for your question. This is caused by a malfunctioning Water Inlet Valve PS16746057. Good luck with your repair.

Hello Mark, thank you for your inquiry. According to our research, the error code E26 indicates that there is an issue with the analogue pressure sensor. We would recommend replacing the float switch. The float switch comes with the housing. The float switch assembly for your model is part number PS8737139. It shuts the water fill valve off if the water level gets too high before the timed fill cycle ends. We hope this information helps!

Hi Rob, thank you for reaching out. According to our research, the E15 error code indicates that there is too much water at the base of the dishwasher. We would suggest checking the diverter assembly, part number PS8737182. It controls the flow of water to the spray arms. If too much water enters the dishwasher, it may start leaking and may reach the electrical components as well. We hope this information helps!

Hi Peter, Thank you for your question. Error code 15 indicates that there is water in the base of the dishwasher and the E17 error code indicates an issue with water flowing into the dishwasher. To see if you can remove the error codes, disconnect the power to the dishwasher for 5 minutes. This should clear the codes. If it returns and there is water in the base of the of the dishwasher, it will need to be removed. Disconnect power and turn the water off to the dishwasher. Then remove the dishwasher from the cabinet and tilt it a 45 degree angle to remove the water. The E15 error code can be caused by using too much detergent or detergent that is not recommended for your dishwasher, clogged or damaged spray arms or leaking hoses. The E17 error code indicates a drainage issue and you should inspect the drain pump and hoses for clogs. Also make sure that the hoses are positioned correctly. We hope this helps!

Hi Manny, Thank you for your question. If there is a blockage on the screens of the water inlet valve, this may cause this issue. Check the screens and see if there is any sediment. If there is use a small brush and gently clean them. Be careful not to use too much force as the screens can be damaged easily. If they become damaged, you will need to replace them. Also make sure that the hot and cold water taps are open all the way. We hope this helps!

Hello Andrew, Thank you for contacting us. This error code means that leak protection system shows water in the base of the dishwasher. We would recommend checking the water inlet valve. Good luck with your repair.

Hello Adam, thank you for reaching out to us. The error code E17 generally indicates a water supply or filling system issue, most commonly a blocked inlet hose, a low water supply, or a faulty water valve or float switch. As you have replaced the water inlet valve recently, replace the float switch, part number PS8737139, to fix the issue. This sensor monitors the water level in the dishwasher and sends signals to the control board. If it's malfunctioning, it could cause the machine to drain unnecessarily. We hope this information helps!