Dishwasher Switch A00055408

Hello Daniel, thank you for reaching out. The error code I30 on your Electrolux dishwasher indicates an internal leak, caused by water collecting in the base of the appliance. The water rises up the float and causes the error. We suggest that you tip the dishwasher over onto the front and then upright again, to remove the water collected in the tray. Also, check the pressure switch, drain hose, water inlet valve, and drain pump. If you require assistance to place an order, please contact customer service. We hope that helps!

Hi Robert,? Thank you for your question. The part number for the float switch is PS10057465. We hope this helps!?

Hi Steven, thank you for reaching out. The error code i20 indicates that the dishwasher is not draining properly. The issue could be with the pressure switch, part number PS12586275. You may need to replace it to fix the issue. We hope this solves your problem!

Hi Venkat, thank you for reaching out. We would suggest checking the door switch first. If it is fine, the issue could be with the control assembly, part number PS16876027. You may need to replace it to fix the issue. We hope this sorts out your problem!

Hello Bruce, thank you for your question. We recommend replacing the Float Switch part PS10057465. Also, ensure that the unit is level. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.

Hello Robert, Thank you for your inquiry. Error code I20 indicates clogged filters or a restricted drain line has been detected, or an issue with the sensor. Check for clogs or kicks in the drain hose and pull out the filter in the drain pump and clean. Test the pressure switch and drain pump with a multimeter. If you are unfamiliar with how a multimeter functions, we have videos available to assist you. We hope this helps and if you need help placing an order for a part, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hi David, Thank you for your question. If there was a smell of plastic melting and there is still some water in the tub, check the drain pump to see if it clogged or damaged. If the drain pump id clogged or damaged it will need to be cleaned out or replaced. If the drain pump is fine, you will need to inspect the dishwasher to see which part is causing the issue. If you have any questions, please let us know.

Hi Carrie, thank you for reaching out. The pressure switch, part number PS11731946, fits your model. If you require assistance to place an order, please contact customer service. We hope that helps!

Hello Stephen, thank you for your inquiry. Error code i30 means the water is too low. It means that the dishwasher thinks it has flooded with water. You will want to uninstall the dishwasher and tip the dishwasher forward 45 degrees to drain any water out that is in the base pan below the dishwasher. Then re-apply power to the dishwasher and try again. If you still get the error i30 there is a pressure switch on this dishwasher, which is supposed to tell the dishwasher when to stop filling with water and tell the control board how much water is in the tub which is reading incorrectly. This pressure switch, part number PS12586275, would need to be replaced to resolve the issue. Good luck with this repair!

Hello Nile, thank you for reaching out. This error code indicates that a leakage has occurred. We would recommend checking the pressure switch, part number PS12586275, to solve the problem. We hope this helps.