Dishwasher Turbidity Sensor WPW10705575

I have a Maytag 665.15114 dw. Apparently the wdt710paym4 Whirlpool is the same unit. Neither spray arms work. I've cleaned them both. I've replaced the water control valve and circulation pump. It drains fine. To test water level i added a couple quarts of additional water after the filling process. I hear a series of clicks from the control panel. It appears to run through the cycles but never spray the water. Help please.

Water is not draining after wash cycle. It will drain if you push the drain cancel button, but it is starting to not drain unless you stop and start the drain cyle a few times. Would replacing the drain pump correct this or does something else control the drain pump?

My Whirlpool dishwasher is not cleaning or drying or running on 1 hour cycle and it only 3 yrs old. Please help, everything is clean as far as filters. Pump is working along with drainage. Seems like a control board issue or sensor. Need advise thank tony

Does not drain unless i press the cancel-drain button before the entire wash cycle is complete.It drains completely when i do this.No blockage,replaced check valve.Any ideas? Thanks,joe.

The dishwasher wasn't draining, so I replaced the pump and motor, and drain pump. We ran a cycle and it still didn't drain all the way. The drain hose is clear. Any clue as to what else it could be?

My unit won't drain at the end of the cycle. If i wait until the water cools and hit cancel, it will drain just fine but it won't do anything if the water in the bottom is still hot. I have replaced the heating element, turbidity sensor, sump pump and cleaned out the hoses. I've powered it off several times with no help either is this a control board issue? Thanks!

Is this likely the best next step? My dishwasher starts and fills, then the panel clicks which may or may not be followed by humming underneath the dishwasher. It waits the appropriate time and then drains and continues. What it doesn't do is spray water through the arms or dispense the detergent. I checked that the arms aren't clogged, checked that the float moves freely, checked whether the inlet valve was clogged, ran a quart of vinegar through it which visibly cleaned some fat out of the drain hose, and checked the door switch with a multimeter and it is fine. This looks like an easy job and i can actually reach it from the front of the machine, but should i be looking at anything else first? Thanks!

Kitchen aid dishwasher does not heat. I have changed the heating coil and thermostat. At times when it completes a cycle the soap door is open and the soap is laying in the bottom of the tub. When it does complete a cycle dishes are wet and not too clean. I have cleaned the screen and filter. It drains fine. Any ideas?

There is very poor water pressure during wash cycle. Water flows in well from he lower fill opening. Float sensor seems to work. It drains well and quickly when prompted. I haven't looked at impeller, but was looking for some direction from here.

Hi, I've had this dishwasher for 10 years now. Still runs fine but lately I'm hearing a squealing sound when the water is filling. This is new to me. Possibly I need to check the pump motor ? i'm stumped. Thanks for your help.