Refrigerator Dispenser Actuator Pad

Unplug refrigerator. Lift and remove cup tray, exposing the two screws. Remove both. Gently pry the plastic bezel/cover from the door facing. Remove the three screws securing the black dispenser/circuit board assembly. Carefully disconnect the three cables from the circuit board (remember how they were routed). Being careful not to lose the spring clip, remove the defective actuator. Place the spring clip on the new actuator post and reattach actuator to the black housing making sure to hook the rear spring clip hook into the hole behind it. Using pliers, pull the front spring clip hook up so that it catches on the assembly post. While the dispenser assembly is off, good time to clean up any dirt, grime, etc from the assembly and door facing. Replace the assembly by reconnecting the three cables and using the three screws. Carefully snap bezel/cover in place and secure with the two screws. Replace cup tray.