Door Hinge - Left or Right Side WP74010284

DOOR HINGE: Lifted the door out of place and layed it on the floor. Removed the six screws (three on top and three on bottom) from the door to remove the front panel exposing the hinges. Removed three screws from each hinge to remove them. Reversed the process to complete. HINGE BRACKET: Would recommend replacing these with hinges. After removing the screws that hold the oven in I pulled the oven out about four inches. Brackets are now easily removed and replaced, two screws each. Slide the oven back resecure and your done. DOOR GASKET: Just pulled it out and snapped in the new.

Once you figure out how to pop the little clips that lock the hinges in place this is not a difficult repair. But, it is tedious due to all the screws on the door.

Fold the door down and look for the tabs on the clips just above the hinge connections. You should able to push the tabs back and down with your fingers. If they are stuck use a flat blade screw driver or pair of pliers. Lift the door straight up and pull back. The hinges may pop (loud) while doing this. Set the door on the floor and proceed to remove the inner door by unscrewing all the sheet metal and machine screws. Lift the inner door out and the two hinges are accessible on either side. There are two black machine screws on the bottom of the inner door that hold each hinge in place. Unscrew those and the hinges come right out. Take the same black machine screws and use them to cut the threads into the new hinges. Remove the screws and install the new hinges. Use the black machine screws to attach the new hinges to the inner door. Reinstall the inner door to the outer. Lift the door assembly back in place on the hinge connectors at the oven. Then, don't forget to push the locking tabs back in place. The hinge replacement is complete.

Removed door, separated deer panels, replaced spring