Freezer Door Gasket

When the gaskets arrived, in only two days, we unpacked them and layed them out overnight to allow them to come to room temp. The next day I emptyed the frig while my son took out the 20 or so screws around the door. We then layed the door panel on the living room floor pulled off the old gasket replaced the new, lined up the panel and replaced the screws. We did have to put blue painters tape on the doors until the gaskets seated. We suggest this might be included with the directions. This was a very easy DIY project. I belive it will ad years of service to the frig. After all it's cheeper to maintain and repair than to replace.

I removed about 25 nuts from the door which held the inside panel in place. Then I removed the old gasket and placed the new one, making sure it was fitting correctly. I replaced the 25 nuts and the door was ready to go. I had to tape the door shut for a couple days so the new gasket could wear in. It took about 15 min.

Once I received the seal/gasket I put it in the dryer on low for 10 mins ( as advised) then I turn the freezer down to 0 and placed a towel over the food to keep it cool. Although the original gasket had rubber with holes to hold the gasket in place the replacement didn't so I found that I had to make sure the gasket was firmly in place while I put the screws back in place. It took an hour or so because I put them in one corner at a time and then tighten them down. I'm swf in my 50s and I did it so anyone can. Also I have long finger nails and still able to do the repair although I drop a few things

only problem was many screws -- like 30 or so -- took a while to get off without a socket wrench and then get back on -- all while the freezer was dripping. Had to do it over a period of time.

used hair dryer to heat section that wasnt sealing. this soften gasket so magnet can can seal . you have to close door wile gasket is still hot.

I was so happy to find a gasket still available for my old refrigerator. This was an easy job, more time consuming than anything, taking out the many screws that held the old gasket in. I am a 74 year old woman, so if I can replace a gasket, I think anyone can. I removed all the screws around the old gasket and pulled it off. Cleaned up the door area with a damp cloth. Soaked the new gasket in warm water to make it pliable, laid it around the door frame, making sure the lip was under the screw in area. I fitted each corner first. Then I started screwing the gasket in place with the old screws starting in the middle of each side. I slowly worked my way around the freezer door until it was done. Easy repair and saved the cost of a new fridge.

I REFERENCED A PARTS SELECT U-TUBE VIDEO ON HOW TO REPLACE A FREEZER DOOR GASKET. (GOOGLE SEARCH "HOW TO REPLACE A FREEZER DOOR GASKET"). THIS MADE THE PROCESS GO QUITE SMOOTHLY.

Removed screws and panel inside door. Cleaned and replaced gasket. Used blue painters tape for a few days to help keep door closed till gasket sealed properly. Easy repair.