The Grate Foot is a black rubber part which attaches underneath the grate in order to protect your stovetop from being scratched, which it does by cushioning the grate on your gas range. If this part ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Carol
December 15, 2023
I need the propane conversion kit to convert this stove top from natural gas to propane. Your site is not clear on the kit. Says $377.00? Not sure this is what I am needing. Please advise.
For model number ZGU384NSM2SS
Hi Carol, thank you for getting in touch. Based on our research, your model does not come with a conversion kit. You may need the following orifices for conversion from natural gas to propane:
The orifice spud is part number PS1481278.
The right front orifice is part number PS1019740.
The right front simmer orifice is part number PS1016856.
We hope that helps!
A rubber grate foot on my range top had worn out. I pulled the worn foot out and installed the new grate foot with no tools or accessories. Good as new! Now I don't have to worry about the grate scraping my range top and scratching the paint. I also ordered extras so I won't have to wait if another wears out.
Fairly easy repair. Remove the grate, then remove the loose fitting burner assemblies. Unscrew 5 screws using Torx (star) screwdrivers - 3 along the ring top and 2 on the inside flat portion of the ring. You'll need 2 different size Torx screwdrivers. Once the screws are removed, lift that piece. It may be stuck from years of baked-on spills, but there's nothing else mechanically holding it. pull off the electrical lead, which is just held with a compression fitting. Use needle-nose pliers to pull off the C-clip holding the igniter in place. Careful not to lose the little spring that the C-clip holds in place, though it's not really under a lot of tension. Change out the igniter and reassemble everything. I used the pliers to push the clip back in place. All set - works like new.
I was pretty upset as the grate wobbled, so I went on line and looked for GE Profile parts. To my amazement, I found the little rubber feet quite easily, and within 2 days they were here at my home. I simply had to stick them in the holes; however, I noted that they did not fit real tight, so I removed them and shot a little glue on them, and they have been in place ever since. Thanks to you guys, I am a happy camper now!!!