If your oven isn’t heating evenly or feels hot around the door, it might be time to replace the door gasket. This flexible seal keeps heat inside the oven, helping your food cook properly and saving e...
If your appliance is starting to dim, the GE Lamp Halogen might just be the solution you need. This 20-watt light bulb not only brightens up your appliance, but also ensures it works at its absolute b...
The GE Oven Door Window Pack Assembly is a genuine OEM part that fits select GE ranges and ovens. It includes a heat-resistant inner glass panel, frame, and seals, providing insulation and clear visib...
Safeguard the long-lasting performance of your GE wall oven with this premium cooling fan kit. The fan serves a major role by continuously circulating air through your oven's control area, keeping vit...
This part is a replacement screw for your oven. It is made of black metal and is sold individually. This screw is approximately 1/4 inch in diameter and about 1/2 inch in length. It is designed to con...
Is sliding your oven rack turning into a workout? Look no further! Our GE Oven Rack Lubricant is here to make your baking efforts a breeze. Formulated to allow your oven racks to glide smoothly, this ...
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wall. Overall, a very easy repair once you get the oven out.
Removed the oven door for easy acces to oven. Unscrewed (philips screwdriver) the screw holding temp sensor in place. Gently pulled the wiring until quick connector was located. Pushed down on locking level on quick connect while holding other end of wiring (so wiring would not fall back behind oven). Connected the new sensor and screwed back in place. Reinstalled oven door. Tested temperature settings by turning on oven and comparing with a separate oven thermometer.
After reviewing the potential causes for the error code, I decided I'd try to change out the temp sensor. Using the ohmeter, I saw the difference immediately between the old and new sensor. The sensor is accessed from the back of the stove, and must be slide out to gain access to the rear panel. Since the stove I have is a built in, removing the stove and the access panel was the hardest part of this repair. Resetting the glass control panel was also a bit tricky to calibrate the touch sensitive buttons. Good luck.
