This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
This lid hinge is a genuine OEM replacement part for your washing machine. This hinge is for the left side of your lid, although it is a good idea to replace btoh hinges at once. The hinge holds up th...
This is the hose that tells your appliance if your tub is at the desired water level.
$79.22
In Stock
Questions And Answers for WTW8000DW4
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Steve
December 20, 2023
E1 AND F3 IS FLASHING ON MY WASHING MACHINE I UNPLUG THE MACHINE AND THEN PLUG IT BACK IN AND THE MACHINE WORK FOR A BIT THEN IT HAPPEN AGAIN. WHAT IS WRONG
For model number WTW8000DW4
Hello Steve, thank you for your inquiry. This error code indicates that the washer can not detect the water level. There may be an issue with the appliance control unit or associated wiring. You may need to check the control board, part number PS12348646, to solve the problem. We hope that helps!
The waste turns on, show the last setup that was used, bur seems to be frozen. Change change any settings and it will not start. I unplugged and plugged bak in but no change. Is there a way to reset the settings?
For model number WTW8000DW4
Hello Pete, thank you for the question. You can reset your whirlpool washer by unplugging it for about 3 minutes from the breaker. Plug it back in and wait for about 30 seconds to turn it on. This way you can perform a hard reset on the machine and it will start over after you reconnect it. Try to run a new wash cycle, to confirm if it is back to normal. We hope this information is helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.
This is a very simple repair. My lid was severely cracked on the back left corner where there seems to be a lot of pressure/torque required to shut the lid. There is a metal L-shaped "tab" that inserts into the lid on both sides of the back edge of the lid. The lid is attached to these metal tabs with two screws for each side. My cracked lid had resulted in the lid breaking off of the metal tab with the screws still anchored into the metal tab.
Make sure screws have been removed from the metal tabs on both sides. Do not remove metal tabs- leave them attached to the washing maching (otherwise, you will not be able to attach the lid back onto the machine). Slide the lid over the tabs. There are square-shaped spaces along the edge of the lid where the tabs slide into the lid. Re-screw the screws into the lid, attaching the lid to the tabs through pre-drilled holes on the sides of the lid. It may take a little time to make sure the screws are properly inserted into the lid and tab screw holes. Tighten up and you're finished.