All Installation Instructions for LG Washer WT901CW

It did not drain water, cycle stops at rinse+spin.

1-Take water off manually. 2- Take machine to back yard. 3- lay machine 45 degrees. 4- Located water bump, (rear left side). 5-removed drain black hoses with hand. 6-removed 3 screws from bump frame. 7-Taker off all unit and marked down cable position at plug. 8- installed new pump. 9- Reverse all steps. Note: I did not use new cable supplied with the new bump, I did not want to mess around on mother board connections, I kept old wire harness which are only two cables blue and gray. It took me less than 30 minutes.

Parts Used:

Washer Drain Pump Assembly

Jesus from El Paso, TX
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set, Wrench set

24 of 32 people found this instruction helpful.

Was this instruction helpful to you?

Thank you for voting!

Drain hose had a pin hole leak external to washer

Very close to the installation video online at Parts Select. Removed the back panel, unclipped the hose from the inner fitting and replaced with the rear hose. Why it didn;t leak on the inside is interesting as there was no clip on the at the inner fitting.
The one difference from the existing install video online was that I didn't have to tip the washer over ~75 degs before replacing. I instead found that I could put to cinder blocks under the back edge to replace the drain hose. This made the job quicker without having to worry about having a box for it to rest on (with any risk of falling to the floor).

Parts Used: