This is an authentic LG water inlet valve for a top-load washer. It is designed to control the flow of water into the washer. If your washer is filling slowly, making loud noises, overflowing, or stop...
This is a pulsator assembly, also known as an agitator, for your washing machine. This pulsator sits at the bottom of your washer and is what is used as the main driving force to wash your clothes. Th...
Getting your LG washing machine back to its top-performing state is quicker and simpler with our genuine Original Equipment Manufacturer (OEM) Motor Assembly Clutch. This part steps in to switch your ...
Facing issues with your LG washer? Get back to seamless laundry days with our LG Washer Motor Stator Assembly. Crafted to match specific LG washing machines, this authentic OEM part is here to restore...
We're excited to share the Cap Cover with you - a genuine, OEM-manufactured part by LG. Specially designed for certain LG washers, it's a critical part of the dispenser cup system, covering up your bl...
Looking to get your LG washing machine spinning like new? Our LG Rotor Assembly might be just what you need! This critical piece connects directly to the spin basket shaft, providing the vital turning...
I diagnosed by running a full wash. I watched it and when the water should have stopped it kept running. I unplugged the washer from the power and the water kept running. This told me the inlet valve was the issue and not an electronic issue. I stopped the water by closing the water valve manually. Replacing the inlet valve was very easy. Hardest part is moving the washer out of the laundry room. The videos online show very simple steps. Maybe 8 screws to remove and a couple of hoses and five electronic connectors. Take a photo of connectors before removing them to ensure you reconnect properly.
The problem was the valve suppling water to the bleach dispenser was not closing completely. This also caused some water leaking towards the front of the washer. Replacing the entire valve assembly was very easy. Unplug the washer, turn off the water, remove the 2 screws that attach the control panel, disconnect the water supplies, unplug the 5 solenoids, remove the hose clamps from the 2 hoses, remove the 3 screws that attach the valve assembly and remove it. Reassemble in reverse order, I did find that applying some water based personal lubricant to the 3 high pressure seals made assembly much easier.
