This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Craig
January 25, 2020
Hi i have a washing macine that just apparently just stopped working. You can hear clicks when you press the buttons but no lights or nothing happens almost as if no power. Remember though i said you can hear the tiny clicks though, so there is apparent power.... i've tried to unplug for 10 minute to no avail... please direct to a possible area i should be looking at for the issue.
For model number WPGT9350C0PL
Hello Craig,
Thank you for your question. Our sources suggest replacing the lid lock switch for your model to fix the washers issues, unfortunately the lid lock switch for your model is discontinued and no longer available from our website. We suggest getting in contact with the manufacturer to find a substitute replacement part that would be compatible to your model. We hope this helps.
Was this helpful?
Thank you for voting!
Jennifer
March 28, 2026
When I start my washer it senses the load then starts to fill then after 7 seconds shuts off and beeps something detected with unit what could this problem be
For model number WPGT9350C0PL
Hello Jennifer, thank you for contacting us. According to the issue description, the problem could be due the water inlet valve, part number PS960664. Sediment, rust, and mineral deposits build up and restrict the water flow to the washer. Washer detects water is not filling fast enough and shuts down. Glad to be of assistance!
First I unplugged the washer. I removed the back of the washer and located the pump.I removed all the water from the pump, then I removed the hoses from the pump. I removed the wires from the pump and removed the two screws holding the pump in. I replaced the pump and reconnected everything. It works like new. The pump was the exact same thing ge sells but it cost a lot less.
Well replacing the pump went fine. I even did a trial run on a rinse and spin cycle and it worked great. Then i ran another cylce of clothes and walked away thinking all is well. Much to my surprise when I went to go through the utility room it was flooded. I did some inspecting and realised that I had put a hose on backwards. LOL. The good thing was that after I fixed the hose all worked well and haven't had any trouble since then. Your company was the cheapest price I found and the quickest delivery. Thank you so much for your help. Sincerly, Chris Lewis
Disconnect power and water lines. Lay the washer on it's back. Remove the nut (300) and washer (305). Rock the motor rotor (215) back and forth while pulling until it comes off the splined shaft. Remove the 3 bolts from the coupling assy (345). Remove the broken coupling (340) . Apply plastic grease to internal spline and gear teeth before reassembling in reverse of above. The machine is engineered to work on easily, however, I would not have needed to work on it if they had made the coupling assembly out of metal. The plastic gear fatigued at the internal spline and cracked apart after only 3.5 years of use.
