This door lock switch is a key component in compatible washing machines, designed to signal the control board when the door is securely closed. Once engaged, it enables the locking mechanism and allow...
$205.79
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
This part is the replacement connector hose or clean-out drain hose for your washer. It is black in color and is sold individually. The connector hose drains water out of the washer if the drain cycle...
$17.44
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
This drain hose plug, also known as a hose cap, is a genuine OEM part for your washing machine. This plug caps the drain hose from the pump housing, and helps prevent leaks from your washer. Before be...
$13.26
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
The tub bearing supports the spin basket shaft at the back of the washing tub. If your washing machine will not spin, is leaking water, or if there is a loud screeching noise during the wash cycle, th...
Is your LG washing machine not performing as it should? It might be time for a new tub bearing. This genuine part, specially made for LG rear tub models, could be exactly what you need. A functioning ...
$86.52
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
This drain pump helps your washer get rid of water after each cycle. If your machine isn’t draining well, is leaking, or making strange noises, this genuine replacement can help. It’s built to last an...
$161.37
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
Questions And Answers for WM1455HVA
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
I removed the Wire and spring from the tub seal and then removed the seal on the side of the washer that contains the Door switch. I removed the two screws that held the door switch in place while holding the switch with my other hand. Once the screws where out I pulled the switch assembly out thru the gap and removed the wires from old assembly. I then plugged the wires into the new assembly aligned the holes up and put the screws back in the new door switch assembly. I then put the door seal and tub seal holder back on. This took about 15 minutes. I do recomend that you unplug the washer before starting this process.
turn washer on it's side. dampers are visible from underneath. use needle nose pliers to "pinch" end of retaining pin and pull pin out. it will take some force to remove. i would recommend replacing all 3 as i had one that had a mounting tab broken off. i then realized the other dampers were bad. there should be resistance in the up and down motion. if not replace.
I took the washer completely apart and ordered any parts that looked worn and put it back together. It’s working like new and will last for a few years
